Search results for query: *

Never mind guys, I found it. I was just having a brain cramp.

I'm sorry Janeenaj, it is in fact CP on a BCM that I'm talking about. I will look at the Outlook anyway, just in case. Thanks.

Well that answers the first question, I am numb! As to the second, I'm running 3.6. What am I doing wrong?

My problem is when receiving more than one FAX at a time. If I receive only one FAX, it land’s in my Call Pilot Message store as a .tif file. From there I can save it to a file, say Service Orders, no problem. If I have received 2 FAX’s for example, I can see both pages, but I cannot find a way...

Are the sets programmed for call forward on busy?

What NARSBARS gave you guys was a first draft. We're still refining it and when done we will post a FAQ, as this seemed to be a stumpper.

If it turns out to be a bad card, might want to talk to NARSBARS, see thread # 798-1098793.

I started using copy because I too heard of coruption when using the move command on earlier software versions. Never had a problem with copy, but it sound's like they have corrected the problem with the move command too. That's good to know, thank's for the update.

First, I agree with mluckie1, that to move the phone from point A to point B it's best to move the crossconnect. If I understand you correctly, you want to move ext. 7426 from TN 6.0.0.0 to TN 11.0.0.11. If that't correct, you can use LD 20: REQ: cpy 1 TYPE: 2009 CFTN: 6.0.0.0...

Try rebooting the Nam a couple more times.

Sorry guys, I'm new at this. Just read somthing else. Viper, your right about the RLI. Once you build an ESA block, you are telling the system that this is my emergency number and I don't care about TGAR's or NCOS's or anything else just send it. At that point the ESA block just wants to know...

Sorry, hit the submit by mistake. The RLI is built in LD86, but 911 is done in ld 24 as ESDN.

Not if your using ESA.

Try this, make your ESDN 911. In your route 31 install a dummy DMI ( one that doesn't do anything.). Now try 9911.

You could "front end" your calls with Auto Att. that says If you want support "A" press 1, if you want support "B" press 2. Then have your CCR tree external transfer to the proper number.

Could it be a bad fastrad? Under Maint., check the port you connected the fastrad to, under device does it show a rad?

You will need to use config ( 266344 ) as the password.