Search results for query: *

Good day. I installed a sip trunk on open scape business it work for a few minutes the goes off for a few minutes then back on again. What could be the issue

Good day. May i have a copy for PC admin for LDK 80,, aria 80 and eMG 80. regards

Good day. Im trying to connect LIP-8048DSS ON LIP-8024E handset it seems not to respond are there settings to enable the DSS to work..?

Good day. Please assist in setting up sect extension on a SBG 1000 PBX system.

Hi. Good day , how do i limit outgoing call duration on analogue trunks in this PBX? Regard

MOD boothttps://files.engineering.com/getfile.aspx?folder=6ef3aead-cc6e-4946-9f78-7b7f6adb3f11&file=MOD_BOOT.txt

Ok I have managed to boot using An MOD.. However the system is giving error LOAD ERROR FOR DATA SUBSYSTEM OF AMO CODEW EXCEPTION CODE : H'8442 The processors are failing to go to the active and standby state...

I also observed the error in quotes... " error reading external RAM NO EXTENDED RAM FOUND FORMAT MEMORY 00000000 0009FFFF 000C0000 0105FFFF 01070000 0120FFFF 01220000 012C0F1F 012C1F20 012D07FF 012D0D73 012D13FF 012D2000 0FFFFFFF COPY BOOT TO LM

additional attachmentshttps://files.engineering.com/getfile.aspx?folder=3c1af212-b302-4649-83fb-12036512e3ca&file=Hipath_4000_extended.txt

Good day.. I have a hipath4K that's failing to startup. I connected a serial cable monitored the boot process, I have attached my findings as well. What could be the problem.https://files.engineering.com/getfile.aspx?folder=e71086e1-87db-4431-b5af-6c3c356ce11e&file=Hipath_4000.txt

The cable is connected to the lower v24 port of the card labelled LBU any idea of the serial port settings if i'm connecting using hyper terminal /comwin, i here the other port is the TMS not sure what is used for an

I have a v24 cabl;e tested

Good day please assist I have a hicom 300 that uses com port for configurations , i would want to know which card(port) i connect to and the serial ports settings..

THE SYSTEM IS FAILING TO KEEP THE SLMAC CARDS ACTIVE AND THERE IS NO LINE VOLTAGE ON THE ACTIVE CARDS..

Good day. thank you so much for your assistance to date. I have been off this system for a while , BCSU is attached above and CODEW will be attached in a bit.. donb01 the DIMEN will also be done in a bit..

1)NOTED MY CONCERN ARE TH SLMAC ON SHELF 1 THERE ARE IN THE CORRECT SLOTS BUT ARE SAYING DEFECT 2)THE SLMO CARDS ARE ACTIVE BUT ARE NO GIVING ANY TONES INCLUDING THE SLMA 24 ON 1-2-109 ITS READY BUT HAS NO DIAL TONE OR LINE VOLTAGE

THE SLMAC CARDS GO GREEN FOR A WHILE AND BACK TO RED

Changed date im ok now im getting defect on all slmac cards and no dial tones or line voltage on the ready ones.

Good day. The hard drive and MO Drive and disk where all bust. However i had a spare MO Disk that is starting up ok but giving the error attached below. How do i go about it??

Thank you very much too bad my system still wont come up unless you can run me thru 7 segment display sequence and its interpretation