Search results for query: *

I haven't run into any issues with this sort of deployment. Of course, Windows VM Pro only supported on R11.0 and earlier releases.

Be sure that H.323 Transformations (VoIP section of Sonicwall config) is disabled.

Hello JoeNewton, Refer to page 3 of the release notes of the patch zip file: To close both vulnerabilities, as per the mitigation steps (Log4j – Apache Log4j Security Vulnerabilities ) provided by the Apache, JndiLookup class is removed from the log4j V2.12.1 libraries used in the...

Hello All, After some back and forth between support teams, the case was escalated to a higher tier of PLDS support and the licenses were re-issued (count mapping corrected). Thank you for all the helpful suggestions. Z

Thanks--I'll post resolution when I get this sorted.

JoConnex--thank you for the reply. I'm actually looking for a total of 16 additional PRI (total of 24 with the 8 already on board) since the PLDS entitlement line item is 8 counts of "IP OFFICE R10+ IP500 T1 ADD 2CHANNELS ADI ENTITL MIGR LIC:CU."

Hello All, I recently upgraded a two site IPO 500v2/SCN solution from R9.1.12 to R11.0 FP4 SP4. When I applied the PLDS license to each unit, a strange thing happened--Voice networking (VCE) and PRI channel entitlements/counts came up short compared to what PLDS portal was showing. For...

From a very old doc: "Use only Lucent Technologies 4400-Series telephone Auxiliary Power Supply Unit (PEC 4499- PWR, comcode 108596412) with the 4424LD+ telephones or with the 4424D+ (when connecting a DSS 4450).

Are you certain you have the right power supply? IIRC, the expansion module for 4424 phones took a "wall wart" style power supply, not a brick.

...and when you reinstall, be sure to run setup with "Run as Administrator" option.

Thanks janni--star for you.

OK--it's SIP trunking to a call manager environment. But the VG2xx parts of such a solution aren't stand-alone (i'm guessing), so re-using the VG2xx components won't be an option. Any preferred/IP Office-friendly pieces to get 16 - 24 analog ports out to a remote location served by a fiber...

Hello all! Would a connection from a 500v2 to a Cisco VG224 analog gateway device require SIP trunk or 3rd party IP endpoint licensing? Thinking one of you has run into this...Thanks! Z

Make sure you have H.323 transformations turned off (found in VoIP section of configuration) on any sonicwall gear. Z

A Mutare solution perhaps?

Make sure that H.323 Transformations are turned off/unticked in the VoIP section of the administration. Z

Thank you tlpeter!

Has anyone had the pleasure of swapping out a bad drive (solid amber light) on a Server Edition DL360? Since the drive in position 2 is still good (and server still up), will the replacement be as straightforward as hot-swapping a replacement drive that is the exact same piece of hardware...

Here's the first few lines of a settings file that I set up that provided a solution to bypass that prompt on a configuration I did: ## VPN Settings for 96xx VPN Phones to work with Sonicwall Firewall ## VPN Mode=Enabled SET NVVPNMODE 1 ## Profile Password SET NVVPNCODE 876 ##VPN user name SET...

What codec are you using? Have you tried adjusting gain on the extension form for the IP extensions in question? Z