Search results for query: *

Hello, I'm looking at buying a switch with IOS for my CCNP exam and I'm planning on spending about $75. I've been looking on ebay and all switches in this range seem to have Catos on them. I have found a couple that have the Catalyst in the name and are still running IOS. Can you upgrade...

The first thing I would try is to try to contain it at the device level. Is there any way to configure this device not to broadcast? Will it affect its fuctionality? The next thing I would do is stick a router or a level3 switch in between this device and your backbone, this should also...

Hello all, I have a basic hardware question about setting up ISIS on a cisco router on serial interfaces. Firstly, all the examples in the book use a subinterface commands for their serial connections on the software side that creates a frame-relay cloud. However, on the hardware side I'm not...

Hello all. I'm having an issue when trying to redistribute my IGP routes from OSPF to eBGP routers. I have 2 OSPF routers setup and they are creating a table b/w them. I also have 2 routers running BGP that are nieghbored and working fine. I have then connected via a serial cable and the link...

Hello all, I'm looking for a MMF cable for a ATM IF card. From the directions I have a "SONET ATM Fiber transiever" UNI card and am looking now for the cable that works. Thanks in advance. -Peter.

The first thing I would make sure of is that you are able to ping both interfaces(E0/E1) gateways from those clients before you ping across. I've setup something similar and ended up setting up a static routing config which is painfully simple with two interfaces. Good luck.

Hello all. I'm having trouble with the syntax of the "network" command when setting up OSPF. I have no problems when I'm configuring all routers/interface in the same area. When I'm trying to configure for interfaces in multiple area's for some reason it isn't recognizing the command. The...

Hello all. I'm having trouble doing some pretty basic commands mainly related to the "network" command while trying to config OSPF with a multiple areas. Can configure for a whole area but not on a per interface basis. My Versions are.... 2501====IOS (tm) 3000 Software (IGS-J-L), Version...

I'm still having trouble getting in now on the console port which on this router is a parallel. I'm trying to connect w/ a straight through parallel cable that eventually turns into a serial b/f connecting to my computer. Do I need a parallel to RJ-45 connector similar to the one I use for my...

For some reason I'm not able to get into either of my 4000 series routers. I think it might have something to do with the "reset" start-config file and ever since it I have been unable to get into the routers. Just a note, I was using the aux port to do config's b/f and now I can't get in at...

Hi all, I'm having issues w/ my cisco 2501/2501 router in that I can't get any of my serial interfaces line protocols to come up. I have switched both serial interfaces and serial cables. This isn't an intermittent problem, as I can't get them to come up. Have no Problems w/ my AUI's, and of...