Search results for query: *

Well, I think I figured this problem out for anybody who runs into this down the line. This may be the solution; I will report back if it is: http://www.watchguard.com/help/docs/fireware/11/en-US/Content/en-US/bovpn/manual/manual_bovpn_tunnel_switching_wsm.html

thread851-1756339 I am still having this problem. I have learned quite a bit more about how the call manager works but I still do not have a solution as to why I do not have 4 digit dialing between remote locations. I am using the SIP SCCP profile on these phones. I am using Cisco Call Manager...

Im sorry Im just now getting back to you on this. I have been very busy lately and concentrating on other IT problems. So I found the DNA section and I ran an analysis on one of the dialed extensions where I am having the problem. It showed up as all correct but it is running the test from the...

I have not run a DNA. Can you help me do that? On CM 8.0.3?

Currently just a data connection. I am eventually planning on switching the cisco phone system out with Digium but I would like for this system to work for the time being. On this particular connection there was a vlan 128 established but I re-routed everything through vlan 1 and the new IP address.

In my switch the Dial Peer is pointing towards the correct location dial-peer voice 1 voip voice-class codec 1 session target ipv4:10.25.101.5 incoming called-number . dtmf-relay h245-alphanumeric ip qos dscp cs5 media no vad The 10.25.101.5 is my Call manager.

The IP's have been changed in the switches and the CM, but still not 4 digit dialing across locations. I can dial 4 digit from my main location to a remote location and a remote location can dial in to the main location (Main location = where CM Server is) but if one of my remote locations tries...

We are using MGCP and H323. Most of my remote locations have an ancient 1861 router with FXO cards and that is where my fax lines hook up. They were originally hooked up via T1 line and I switched the connection to broadband and set up vpn's via watchguards. Im thinking it might have something...

Yes, due to other reasons besides call manager I had to change internal IP addresses at my locations.

I am running CUCM 8.0.3 on my network. I recently upgraded some of my remote locations from antiquated T1 connections to broadband VPN connections (with PFSense / Watchguard Firewalls). All of my remote locations have lost 4 digit dialing but I can still dial the 7 digit outside DID number and...