Search results for query: *

I don't have a 1000e. It's a cs1000MG. An 81C upgraded with 5.5 software. There isn't any SSC card.

How many conferences can a CS1000MG 5.5 have? I currently have 14 conf/tds cards. I read somewhere that it can have 64 conferences at one time and each conference can have 6 parties. Is that correct?

I had one of the managers at our clinic change the password of her call pilot and doesn't know what it is now. It's been a while since I've done this, but from what I remember don't you press F985 then press 1 and enter the resetXXXXXXX?

What is the lease time for IP sets in the DHCP scope. I know it's option 51, but nothing states the lease time.

How long should the lease time be for an IP set in the DHCP scope? I show to have the DHCP scope use option 51, but nothing about a timer.

I can look into the QSIG, but the weird thing is we have two programmed the same, but only one has the issue. Could we get those errors from a possible bad cable?

Yes. That is the way the vendor for the Call Manager wanted it.

PRI0226 Protocol Error: No RESTart ACK message received. Output data: DCH: x DATA: y . Where: x = D-channel number and y = UTN. Contact your technical support group if the problem persists. Severity: Critical What would be causing this? When I reset the DCH it seems to clear up for a couple...

I did a trace and showed it going out LP 18 (network) and tested a phone with that same result when I traced so...I will look into the fax driver.

Here is a good one. I have a Right Fax server connected to our CS1000M via T1 so when it dials a number it will use the TIE line to the PBX and dial out from there. I can dial any 866 toll free number, but 1. When I dial that 1 specific number 1866-812-XXXX it shows going out a member on our...

We had a problem where we couldn't get any incomming calls. Everything looked good on our end. The DCH were up and channels were IDLE, but no calls could come in. I disabled the DCH so it would bounce to the back up then everything worked. I know there was a patch for 3.0, but we're on 4.5 and...

Does anyone know how to schedule reports to a file. I know when our CC6 was installed a while back it took our vendor a week to figure it out and it wasn't easy. I had to have a folder created on the admin server for each department which our IS security would give each manager access to. Then...

If the NCOS is 0 for the TIE lines so any NCOS of the incomming trunks should work.

What does the N 040 00 and N 045 00 stand for?

This is typically a local CO issue.

If my NCOS is 0 on the T1 then it should matter what the NCOS is on the incomming trunks correct?

I have a T1 that is connected to a RAS server for people who still actually dial in for VPN. I can call the number internally and it works fine, but it fails if I call from the outside world. The NCOS is set to 0 on all of the TIE trunks into the RAS and the TGAR is set to 9 so it isn't the same...