Hi Larry,
I got it working ! It was a Termination issue. For some reason the manual termination jumpers would not work, nor would the "auto" setting within the adaptec card work. I had to either install and ACTIVE terminator on the other side of the channel or set the software to terminate at...
Hum, I only have one cable attached right now using one server. I looked at the internal switches and the EXP300 box is configured to have a split backplane. I did not want to change that for fear of messing up and data/raid relationships right now. The box is fully filled with drives (14)...
Question folks,
I am a totally newbe to IBM Exp 300 Arrays, but they look fun and I have experience with other Raid controllers. I have the Array attached to an Adaptec Ultra2 (80meg/sec) non-raid controller, using the correct cabling but when I boot the NT4 server it does not see any drive...
Question, in the example above. And someone goes into Vlan Port Configuration, and have the PVID for Vlan 2-4 Enabled. Does that mean that a workstation can talk over more thank one Vlan ?
And if so, um... what does the question line from Hungryhouse "Since you still can have only (1)PVID...
I have having similar problems with Baystack 450-24T's . We have five of them in a stack w/i cables, but the Vlan's seem to be a bear. I have upgraded to the latest software, and am using the console port.
I have checked the pvid's, they seem to be all configured as per -Switch config, VLAN...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.