Recent content by vippadil

Hello to all, hope you are doing great!!! I wanted to know if i can configure a Cisco Aironet 1131AG access point as repeater, but with non-cisco AP as a parent is that possible? and if it is possible could give some tips of the configuration i need to have that working, i will be very...

Hi to all!!! I got a question, what i'm trying to do is: I have 2 scenarios First Scenario Configure Cisco AP with different ssid's but with the same vlan, but i don't really know if there is an option to do this or if i need to create vlans to get this working. Second Scenario Configure...

Hi Andy that part of the mbssid guest-mode worked thanks, but i got another question, what i'm trying to do is: I have 2 scenarios First Scenario Configure Cisco AP with different ssid's but with the same vlan, but i don't really know if there is an option to do this or if i need to create...

Thanks Andy let me try that command i will let you know if is working. Thanks

Hi to all!!! I'm trying to configure from the initial setup a Cisco AIR-AP1131AG-A-K9 what i'm trying to do is to generate a simple SSID with WEP or WPA security, i'm very newly un Cisco but i've noticed that i have 4 interfaces, what i did without good result was. - Enter to the interface...

hi montyzummer !!! thanks for the info, i will take a look of the document, i hope will be useful. thanks again.

Hi montyzummer First of all thanks for yout help, I made a display errors command and the result shows many errors but for that trunk group in specific is the following: Port Mtce Name Alt Name Err Type Aux Data First Occur Last Occur Err Cnt Err Rt Rt Hr State Ac 01A07 UDS1-BD...

Hi to all Since this morning one of the main trunks group keeps failing when you try to make a call sounds like occupied, when this happens i reset the trunk with the command busyout trunk 4 and release trunk 4 and the trunk function again but in a few minutes the same, the trunk goes down, y...

Hi to all!!! Anyone heeelp please someone could help mee!!! i need this info to solve some problems in my work. Heeeelppp thanks in advance!!!

Hi to all!! I have a question i'm going to take the CCNA course and reading a little on the internet of the topics i am in a middle of a doubt. I understand that if you want to communicate from 1 host(PC) to another host(pc) in the same segment (subnet), the OSI model tells you, the...

Thanks to all for your help and tips . . . t seems it's working right know. . .[thumbsup]

Hi tony sorry for the delay, i was repairing some problems jejeje, with your help and tips you just gave me, right now it's working with the SAC button!!!, i just made test and worked just the way i wanted to, i really appreciate your help and i'm very grateful, i worked in a manufacturing...

ok Toni, first for all thanks for your time and tips, returning to my problem, in the send-calls button only allow me to put an extension nothing else, if i try to put a remote cover, VDN,etc, sends an error, am i doing it wrong or configuring bad the SAC? or you mean configure a button with...

Yes i did what MikeyDidIt suggested, and the same, if i make a call to the ext 29 directly, the call works ok, and yes i also tried with the remote coverage, because all the test i made i think what is not working is specifically the SAC button. any other ideas? what i need to get it work is...

I made another test, i put a normal extension in the SAC button and does not work too, what do you think is wrong, first of all i think i have to get it work the SAC button because i think in that point is the problem, because the button does not work there is something that needs to be...