Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by tphethai

  1. tphethai

    6509 Sup2 Bootflash issue

    #format bootflash: MSFC(boot)(config)# boot bootldr bootflash:c6msfc2-boot-mz.121-26.E1 MSFC(boot)(config)# boot system flash sup-slot0:c6msfc2-jsv-mz.121-19.E1.bin MSFC(boot)# show boot read more: http://cisconetworkingcenter.blogspot.jp/2012/09/network-diagram-templates.html...
  2. tphethai

    YUM and/or RPM install problem

    yum remove first... check yum repolist then yum install from remi
  3. tphethai

    RHEL - how to get LVM to recognize a drive size change

    PV PV PV PV ----------------------- | VG | ---LV----------LV----- PV Physical Volume VG Volume Group LV Logical Volume #vgdisplay #vgs #vgscan
  4. tphethai

    Port-channel question

    match your concept, i found it@first-hop-redundancy-protocol
  5. tphethai

    router or domain controller for DHCP?

    this may help DHCP
  6. tphethai

    Problems with Cisco Router config and ACLs

    ip local pool Remote_VPN xxx.xx.xx.xx xxx.xxx.xxx.xx ip forward-protocol nd ip route 0.0.0.0 0.0.0.0 xxxx
  7. tphethai

    Cisco Router configuration - help required

    use the same protocol and same model, compare the configuration... it should be worked
  8. tphethai

    keyboard not working at all in Tera Term and Hyper Terminal

    driver problem? or use the wrong serial port
  9. tphethai

    Cisco 881 router basic setup

    don't forget to run hardening on your cisco internet router..[2thumbsup]
  10. tphethai

    Communicating between VLANs issue

    The analysis process follows these steps: 1 . Can the workstation communicate with any other device on the subnetwork? If no, then go to step 2. If yes, determine if only the server is unreachable. If only the server cannot be reached, this suggests a server problem. Confirm by doing step 2...
  11. tphethai

    Shutdown Catalyst 6509 PSU remotely

    you just power the switch off. There is no way to shut the switch down at the command line.[bigsmile]
  12. tphethai

    Routing traffic to different Lans

    sample config on switch ! interface GigabitEthernet1/0/5 switchport access vlan 30 switchport mode access switchport voice vlan 20 ip arp inspection limit rate 50 srr-queue bandwidth share 10 10 60 20 srr-queue bandwidth shape 10 0 0 0 priority-queue out mls qos trust dscp...
  13. tphethai

    Network Monitor between sites

    have you ever used Netscount and Solarwind packetflow interface GigabitEthernet0/0 description *** connected to SGHQSL2-6509 G1/1 *** ip address 156.50.200.198 255.255.255.252 no ip redirects no ip proxy-arp ip pim sparse-mode no ip route-cache cef ip route-cache flow no ip mroute-cache...
  14. tphethai

    CDP

    some out put sample case on 6509 ___________________________________________________________________________ Port (Our Port): 3/4 Device-ID: sgdcSL5-4506.sgdc.chevrontexaco.net Device Addresses: IP Address: 123.55.193.4 Holdtime: 176 sec Capabilities: ROUTER SWITCH IGMP Version...
  15. tphethai

    simple design question

    Hierarchical model can be apply to your network more info here: http://cisconetworkingcenter.blogspot.com/2012/03/cisco-hierarchical-model.html
See more

Part and Inventory Search

Back
Top