Recent content by thertel00

Ok. Thanks. They are MGCP btw...

How does UCM communicate with its gateways? I need to change the passwords on my routers, but do not want to affect anything.

My OWA Users are having indexing issues. When a search is performed, they get "Search results may take a long time to appear because Microsoft Exchange Search is unavailable. Results will not include matches in the e-mail body." MS says the index needs to be rebuilt. Here is my question: Do I...

Is there a way in UCM 6.1 to see what physical device an extension is logged into? I can see what device profile an extension is assigned to, but how do I see what physical device it is applied to short of going set by set?

Everything was correct in the system. I rebooted my UCM's last night and it fixed the problem.

CCM Says it is not logged on. I even went as far as doing a factory reset on the phone. When it comes back up, the webUI still says the DN is 5422. This is wierd.

I have a 7941 at a remote site. The phone is logged out but still shows the username/extension. I have reset it by having the user unplug the cable, and also sent a reset from UCM. Any ideas?

I just ran an EDD and it processed successfully. How do I add it to DROL?

Do I need to to the EDD after hours or can I do it anytime?

Here is what I get from LD 22 >ld 22 PT2000 REQ prt TYPE ovly OVLY SID 0 BKGD 044 PBXH 01 TODR 01 DROL 030 034 038 044 135 MULTI_USER ON

How do I check to see when the last time it was run? Can I run it manually?

I recently powered down my option 11c to move it to a new location. When I brought it back up, all the changes I had made in the last few months were not in the switch. What is the deal with that? Luckily, I use OTM and was able to identify non-working sets and retransmit the changes. How do I...

"If you have any TTYs programmed against the FBR RCVR cards, you might want to remove those from programming as well." How do I check this? How do I out the cards?

I currently have an option 11c. We are moving our office and downsizing so I only want to use 2 of the 3 cabinets. Do I need to do anything in the switch before I take the 3rd cabinet offline besides moving the sets that are on those cards? This cabinet only contains 3 Digital LC's and 2 Analog...

My CallPilot hard drive failed this week so I bought a CD drive do I can rebuild it. It is a wide-SCSI drive, but I have the proper adapter cable and terminator on it so that it should be compatible with the SE interface. I boot the server into rom-dos and try to install NT but I get the...