Recent content by telman2010

It sounds like the software you recieved is SAT which is pc programming of the switch itself, won't do anything for the voicemail. You'll need cosessions software to program the voicemail. It plugs directly into the 9 pin connector on the front of the voicemail.

The file comes out in a .aud or .vox format. You'll have to find a media converter to change it over to something like .wav

The ipk has an extenal page port as well. Its on the side by the amphenol connections( RCA Type Plug). The default code for external paging is "55".

Optus Telequip deals in buying and selling of used equipment. 870-974-7700 or www.optustelequip.com

Phone switch uhh...memory block 3-62 I think. Don't have a manual right here in front of me but that should be pretty close to the right memory block.

You can either do a delay ring on the first port of voicemail or you can do a delay DIT to the first port of voicemail. Either way works fine. Most likely your lines are DIT to voicemail right now so the easiest thing to do would be to set up selay DIT.

that means it is broken out further than just "0". You'll have to go with "00" "01" "02" so forth and so on. It may even be broken out further "000" "001" "002

Yup, forgot about that part.

get into moc mode hit f9 enter 10 , hit the spacebar, enter your lens number for the first port in that slot, enter the station number you want assigned to that port and hit either f2 or "." key and the info will be written into memory.

Are you familar with CAT or MOC mode?

Yup its true, if your trying to do analog caller ID. If doing PRI or something similar then you don't.

To jsaad: The conference bridge card works pretty well. I've put it in several 192's and ipk's and its easy to install and easy to use. As to the fowarding, yes you can foward to external numbers, but it has to be setup in programming to allow it. To Luke: If the login and password aren't just...

Check command 9001 and see if its set to ring.

Also need to be on port 5 of the system to programm.

Yes the CT10 is compatible.