You could try to add the second extension as a shared user on the first extension mailbox that way when the message is left. The second extension can get the message indication and retrieve the voicemail from the first mailbox.
I find that when I am at a customer's site that needs one they tend to have a lot of phones that are not wall mounted and I take from the bases on those ones to replace the wall mounted phones that are missing the hook switch clips.
You can also turn on the operator in the call pilot and direct it to the same location as the dial 0 point or any extension if you don't want to get "the operator is not available message".
IPO500 V1, running 10.1 is not supported. IPO500 V1 is only supported up to version 9.0.
As well 5410 sets are only supported to 9.1. Maybe that is why you are having so many issues.
There is no real Reboot Procedure.
Do you want to do a Soft Reboot or a hard Reboot.
This is for the CS1000
For a hard reboot (you onsite in front of System)
Recommend being on port 0 as you will see boot-up routine
Always do a ld 43 edd 1st (unless you have a issue which started before last...
Are you using any custom cabling to connect the ATA2 to the ZipLink on either end? Also how far apart are the 2 buildings ZipLink requires a minimum of 20-25 feet for proper operation.
I have run into this issue before once and we deleted the 3rd and 4th card from the control unit and then rebooted the system without the cards in and then rebooted the system with the cards in and when it came back up it resolved the issue.
I would upgrade the system to the latest version of 9.1.12
I have seen a few people have issues with 9.1.5 and below.
There are other threads about older releases of 9.1 causing issues with expansion modules.
https://www.tek-tips.com/viewthread.cfm?qid=1760828
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.