Recent content by telco71

two options from what i have done. if you have an amp, then you most likely have 70 volt speakers. can see tap on back of amp to verify. you can add speakers and one good thing is your volume is set from amp. the other way is self amp speakers from viking, requires a transformer and 2...

just installed a mics 7.0 and added a flash 2.2. everything working except if you use the voicemail transfer button f986 it ask for mailbox and then after dialing mailbox is displays not allow. can transfer to ext and it goes into voicemail but not thru vmtr. have ck feature codes...

did not know the test sequence but that was it. sprayed wd40 on board contacts for port 5 and it worked. must have been some corrosion on the contacts. new board was a CID board and didnt match the non caller id board so the system did not come up. put the old board back in, restarted system...

have 3 console in a business and line 5 will not pull up. has a red light when touched but will not go green to access line. line is good to board, swapped ports and works in other ports, check status and busy out in maintenance and shows idle, have power off to reset system and even changed...

Thanks culycord but i do not have a physical phone on this station to call fwd from. was just trying to do it from programming in system. guess i could install the station in phone rm and use it as a physical station to set call fwd but short on ports................thanks anyway

Have a mics 7.1 pri. i have a did number with no phone that the customer wants to fwd out to a cell phone. i guess he has no one in the office at this did number. i set up the station and under capability set call fwd to 9 plus the cell number but calling the did it rings in on main rep...

have an existing mics that has 3 digit station numbers with a PRI. the target DID numbers ring in on the 3 digit station numbers. the customer whats to change the 3 digit station numbers to 4 digit to match the DID numbers which i think is not an issue but the system has a call pilot 100 on it...

remember i have a compact ics, rel 4 i believe. been in for 15 years or so in a house no less. when it lost power it reset system to January 1 or default because of the battery being dead. did replace button battery and reprogrammed. but did not have a chance to ever see the original...

i have assumed that the first time i tested the door phone after reprogramming, station 21 was the only set that would ring. under station programming is the prime set for the door intercom which is 34 set for 21. i have gone from the location so cannot see that in programming. but why by...

have Nortel compact ics that lost battery and programming. change battery, reprogram system and added all phones on answer DN for station 21 to have door bell ring all phones. works great. line two on phone system is a fax line but put on system to have another line when not in use. it is set...

Thank you.

Had a nam go down (unknown release) and it was on a mics 5.0. replaced the nam with a 4.0c 8 channel and everything works except outside calls after hours you can ring the station number but does not go to the station voicemail. just blank recording and then say exiting the system. Have two...

I would like to change the class of service to stop the resetting of personnel mailbox password. the older nam did not have the owners keep changeing their mailbox password every 2-3 months. but how do you get in the class of service or how do you turn off the time limit for changeing...

I do not think that a cold start will loose your pri. maybe someone else can vertify that. telco 71

have had issues with low volume on compact ics 7.0 have changed the trunk cards to the latest version with solid state relays, have set the volume on the sets to allow the system to deal with the volume, but does changeing the trunk loss from the default of medium to something else help to...