Recent content by tech1971

Thanks guys port 69 was TCP instead of UDP. Now having audio problems.

We have gone through setting up the teleworker phone which is a 5330 phone. When we get the phone off-site, it goes through its loading process and it actually comes up for a few seconds. Then it goes it "HTML download" and stays there. You can dial out, it rings the number calling, but...

I am setting up for the first time a Mitel with a PRI. I am having issues with analog phones not ringing like they should. They will ring once or twice and the ring volume goes way down. Any advise would be appreciated.

I am assuming the change would be made under "timers and Limits" but what option would you change? Thanks for your help.

I have a mitel 5000, and having issues with loop start trunks not releasing. I work for local telco, and each line has COD. Any ideas?

I have gone through the process of adding new WLAN sets. The phones work fine, they can make and receive calls. The problem is when I add a second DN on the 6120, to match what the customer already has on their 1220/1230, it will ring but I cannot answer. I am also using SRG at the individual...

Thanks

I have not tried to out or flush the phone, and I hope I don't have to. There is about 80 phones. Thanks, Jamie

Here you go I should have done this in the beginning TN 220 0 00 00 DATE PAGE DES DES TESTPH TN 220 0 00 00 VIRTUAL TYPE 1230 CDEN 8D CTYP XDLC CUST 0 NUID NHTN CFG_ZONE 003 CUR_ZONE 003 ERL 0 ECL 0 FDN 7050 TGAR 2 LDN NO NCOS 2 SGRP 0 RNPG 701 SCI 0 SSU LNRS 16 XLST CLS UNR FBA...

I have a CS1000 with a mixture of 1220s and 1230s. I have the message button (when pressed it goes directly to their voicemail box) on the 1220s working, but can't seem to get the button to work on the 1230s. Thanks for any help.

yes, I have licenses. Thanks

Thanks, I work for the local telco that is installing this pbx. So, yes it is our DMS100.

Thanks for your help, We are doing the 911 addressing through our dms100 in the CO, so this shouldn't be a problem then right?

I want to be able to set the main number to be the number sent out from the pbx whenever someone dials out. I have 10 different locations,(on the same PBX tied together through a network) the customer wants to send the main number from each location no matter what ext/dn they are dialing from...

I am working with a school system that has 1st call email software. They want desktop messaging, is that possible. According to documentation its not, but our TAC group says it is. Any help would be appreciated. Thanks