Recent content by TDN2007

thanx alot, I'll do it.

Hi all, I have one of BES 110 when i tried to run it, it gives me this massage : Booting... Testing main memory - PASSED Starting.. Business Ethernet Switch BES110-24T Boot Version 1.0.0.4 Wed Jan 17 15:13:18 2007 Hardware Rev: 03 Resets: 4 Initializing Flash.. Reading MAC...

Hi DaddyOfThree, i have ERS-8300 SW.4.03 on the core and ERS-2500 SW.4.2 on the edge,Could you tell me how to do the bouncing of the IST link? please, thank again for your help. best regards.

yes i am, when i disconnect one of the fiber link (up link) it works, i run an smlt on my network. is there any reason for that?!!(note the server of these sales point is connect directly to one of the cores)

Hi all, i have this odd problem, i have multiple sale-points connected to the same switch 1 is working and the other 2 does not when i connected these 2 directly to the core they worked!!!, but in the edge switch they did not,although the 3 sale-point have the same port configuration and work...

Hi, it seems that Nortel Guy mismatch the shipping item, so that it is there fault, and i am waiting the license from them. thanx for you help.

Hi all, i used to use ERS 2500 switches with licensing stack to make a stack of 2500 switches, and that work fine. but i get some new switches from nortel with stack factory enabled feature, when i log in to the switch and try to change the mode of rare ports to stack mode, it return to stand...

Hi all, thanks for your help, but the problem was not from switch the IP phone was missing some necessary parameters. and yes V4.2 on ERS 2500 support ADAC and work quit good. best regards.

Hi all, I was configuring the ADAC option for some site, i have ERS 2500 V4.2 on the edge, and 8300 on the core, I do the configuration as the following: Operation Mode? UntaggedFrameAdvance , voice vlan (70 which is the IP Phone Vlan), the uplink port is the trunk port from the edge to core...

thanks biv343, yes it get some problem on XP too.

Hi all, i know this section is for Nortel but Trapeze MX-200R is exactly like Nortel WSS 2382,so my question is how i can make hidden SSID that does not appear on radio scanning? thanks.

Hi all, i think a found the solution. i should chang the DM used from Edit->Preferences->General then change the device manger from bundled to the path of new one DM . best regards

Hi all, i have both the latest ESM v6.2 and the JDM v6.16 the ESM came with its own JDM which is v6.09, i want the ESM to lunch JDM i installed which is v.6.61 because of the new image of the ERS 2500 v4.2, My question is how to do so, if there is any one tried to do this? please any help...

Have you tried to enable spanning-tree bpdu filtering. i think this will cover it. best regards.

OK thanks Best Regards.