Recent content by tbonz25

One last request you indicate that this call goes across a T-1 from Cisco to the CS1000 where it then goes to the PSTN (Carrier) can I get the dchannel trace for both the Tie line between the Cisco and CS100 and the carrier T-1 the call goes out on sorry for all the traces but I think this will...

Can you activate both the incoming and outgoing dchannel messages you only have the incoming turned on in these traces. The command is the same just need to activate ENL MSGI XX (XX being the dchannel number) and ENL MSGO XX thanks.

Can you attach the dchannel traces you pulled as there may be some information that will assist troubleshooting this issue thanks.

When any 11xx series phone boots up if a provisioning server IP address i.e. tftp server is assigned the phone will reach out to that server for 2 files the 11xx.cfg and the system.prv files. If a provisioning server is not specified it will use the default files on the phone itself. Also that...

I have copied a working .prv file below I hope this helps as far as the format goes. Also it does need to be a TFTP server not an FTP. # Options s1ip=192.168.30.17; # Primary server IP address p1=4100; # Primary server port number a1=1...

Have you run a d-channel trace to see what is happening when the call gets redirected?

What about setting EXTT and TRNX to yes in the customer data block.

Yes I would set them all to match this may not fix the issue but is much cleaner. Also you may want to look at the FRL on the routes as the NCOS needs to match or exceed the FRL on the route.

Check the customer data block and make sure you have EXTT and TRNX set to yes. These are the 2 prompts that control external trunk to trunk transfers.

Did you configure the AML and VAS ID for the SIP Line Gateway?

Awesome glad I could help.

I would say there are 2 options at this point if you have access to another CPMGS you could try to put the hard drive on another card and see if it will boot up. I am not sure you would be able to repair the files but also notice there are bus errors in the message so that's why trying another...

Does the MGC part of the card work is it registering? It sounds like a bad hard drive on the card to me. You could try to reload software and do a restore if you have a good backup but I would have a hard drive handy as it sounds more like the issue.

The script looks ok I assume you have an access DN of 19240 that points to that announcement. If you need to de-aquire the ports you can go into load 48 and run the DACR ALL prompt on the 2 Links to take down all the ports referenced by both callpilot and AACC and reboot in the proper order.

Sound files must be mono 8-bit or 16-bit files in WAV format, with a sampling frequency rate of 11 kHz, 22.05 kHz, or 44.1 kHz. Also you may have to reboot both the AACC and Callpilot and in the proper order. Take both down and then boot up the AACC to come up first completely and the boot the...