Recent content by rsatech

I need assistance on setting up least cost routing on an Ipecs Cloud. I have installed the Trunk Gateway (LGCM4) and also the TDM Channel license. I can receive calls via the Gateway but do not know how to access the gateway for outgoing calls. Any assistance would be appreciated

Hi, Try using a different browser (you don't mention it)

Hi Cody64 thank you for the support, its just when I use your above setup the Offnet stops working altogether. Is there anything else that requires changing with your setup https://files.engineering.com/getfile.aspx?folder=c8bab193-a053-44b0-bc4f-0e150ac99928&file=Cody64.png

After setting up offnet fwd via a speed dial, I require the original callers number to be displayed on the received mobile phone, I am using SIP Trunks. Has anyone had experience with this before. Your assistance would be appreciated

Trying to install/ activate the external MOH on main MSU. Does not seem to work. Connected external device to pin 1+2 (Orange-Orange/white) Please Help!! Works ok on an emg 80

Hi, Does anyone know how to setup Scenario Ring Modes on an Ipecs UCP. The manual is very basic

Thank you JanVanDriver worked perfectly....much appreciated

The problem occurs when a user puts in the wrong Auth code a few times. The system then puts the user’s COS out of service temporarily. If the station does not have an Auth code yet, set up an auth code for the affected station e.g. station 7234 with WebAdmin or from operator’s terminal with...

Hi, My customer has created passwords for all the 9x conference rooms and has misplaced it. Is there anyway the Conference Room passwords can be removed, so that everything is back to its default state

How many Ip extensions can an emg80 support. Do I require a system license for Ip phones

Hi Everyone, Has anyone expreienced a problem with a MFIM 1200 where the IP phones/digital phones experience slow responce rate/just hangs when the pabx is flooded with incoming calls. I tried using a MFIM 600 and it does not have the same problem.

Hi Cody 64, how did you solve your problem with the H323 ALG being in your router. Did you simply disable the ALG in the router? I am experiencing the same problem. Please reply

Thx xs650, that works, any ideas what to do, since I have 4x different sites that need to be connected this way, and I need to share all channels among them.

If yes, what are the pin outs your using?

Do you have a call management system connected to the PABX?