Recent content by rinop

WOW !!! You're G R E A T E S T It's that i want ! Many many thanks!

you are a legend, doctor. many many thanks. [thumbsup2]

In the Alex v. 4.2 i have not found this mml command. In winfiol 5.2, the mml command FTSAS works but i do not know the parameters required <FTSAS; NOT ACCEPTED MISSING PARAMETER SIGAR Can you give me this information?

basically you can do with a phone directly on the card or on the telephone line. tks doktor, I was hoping there was a command that does not know.

<GEPEI:DIR=2921,PROC=B21B; NOT ACCEPTED DIR=2921 NOT GENERIC EXTENSION <

HI GUYS, can you help me about is possible from MML command to cancel a follow me from digital or analogic phone ? I know that is possible only by digiting #21# on phone, it's true? I'm in BC11SP12 market: Italy. Tks in advance

Hi to everyone, i have a MD110 in BC11/SP12 and i use two TLU79 for BRI TRUNK with a Cisco 2811. Now, when i call from a one of these, appears the GNR at B; i'm try to set NUTRY to convert to right number but nothing. Have anyone some ideas ? (sorry for my english, i'm Italian)

This morning I tested the cable and works perfectly. This pinout work fine: RJ45<-->DB9 --- SIGNAL pin1<-->pin5 --- GND pin2<-->pin2 --- TX<-->RX pin3<-->pin3 --- RX<-->TX pin7<-->pin4 --- DTR Thank you Denny for your support. Rino P.

thank you Denny for your reply. In fact I built a rj45 cable with those specific (V.24) to db9 connector : RJ45<-->DB9----SIGNAL pin1<-->pin5---GND pin2<-->pin2---TX<-->RX pin3<-->pin3---RX<-->TX pin7<-->pin4---DTR It's right or wrong ?

Hi to all, I want to be connect from PC to COM4 of AAU2 directly for setup checking . I have set winfiol 5.1 with these settings: protocol: rs232 mode: setup with checked "open port...." setup: Com8,9600,8,n,1,xon/xoff,dtr+rts checked (com8 because I've an pcmcia/serial interface on my laptop)...

<LCLDP:LIM=ALL; NOT ACCEPTED AC/DEST NOT ASSIGNED

now i have this: <LCDDP:TAB=DNT1; LEAST COST DESTINATION DATA EXCEPTIONS TABLE ENTRY TRC PRE ACCT FRCT TOLL CBCS BTON TNS OSA 00090 1 10122 0 1 111111111111111 0 00098 1 10122 0 1 111111111111111...

NO, i'm using a simply LCR to many carrier (price list to be convenient). I'm using one for default (DNT2 table) and the other prefix to be process are in the DNT1. That has worked properly for 3 year without problem.

HI all, until some month ago everything was working well and without problems. For some month I have changed the tail carrier preselection have and ever since on a few telephones he works on others not, I better explain that is if I take a channel from T1 with Roddi and manually dial all the...

in fact I have done last Sunday when there was none or almost that he used the telephones and have solved successfully him. I still thank all the forum members for the given advices