Recent content by refted

I tried to set programmable button for Direct To Voicemail; we are using Mitel Connect Director, Build 22.18.4600.0. None of the buttons will work when I add this feature. The top right button (button 5?) returns a SAVE? when pressed. TIA for any ideas you may have.

Because we were desperate to get an answer. Thanks.

Thank you Curlycord! Worked like a charm. Have a good weekend, eh?

I am working with Peachew on this problem. SP:30MVJ24 DR5. System lost programming. Service Modes: Control Sets: set to Ext 232 for all lines (reception). Name1:NIGHT: Set to Manual, Trunk Ans-YES, ExtraDial:282 (VMpilot #) Line:001 No ringing sets. Do not understand why the AA is not picking...

SP:30MVJ24 DR5. System lost programming. Service Modes: Control Sets: set to Ext 232 for all lines (reception). Name1:NIGHT: Set to Manual, Trunk Ans-YES, ExtraDial:282 (VMpilot #) Line:001 No ringing sets. Do not understand why the AA is not picking up. Prime set is set to none for all...

It turns out that Telco SAID they were sending 3110 on the new test number; in fact they were sending 0311, so if I numbered my set to 311 or 3110 it would land there, but if I said expect 4, 3110, strip 4 and add 28 it would not work. I proved what they were sending with the Monitor tool...

Tommy, Thanks for the help. I did that to manipulate the DIDs. If I renumber an extension to 3108 it comes through, but if not it goes to the Oper (should go to x28). A Slot 6 Switch: 5ESS A System: By line A BchnlGrp #: Slot: TestTelNum...

I am installing a new PRI on Merlin Magix- DIDs are completely out of order- 4 main lines will come in and need to be sent to QCC consoles (2). How can I point them to the LDN? Do I need to renumber the LDN? Also on the PRI I am deleting 2 and adding 1 digit, but there is no where to 'add' the 1...

Belevedere, I've searched the CMD Maual- there are no directions to assign a CID button. Neax- The CMD Manual for 13 doesn't go up to 69. I'll be at the site later today, but am I missing something? Thanks in advance!

Newly certified SV8300 Tech- does anyone know how to program CID on 2nd call (rollover appearance) on ITL-12D and 6D sets? Thanks in advance for any help...

Thanks again.

So to confirm, the CID is NOT displayed while the call is ringing? If not, I have the same deal working with ACS 5 and PVM Large Card. Please confirm whether you get the CID before the call is answered. Thanks for all of your help!

Can anyone tell me if ACS 6.0 with Messaging 6 will pass the CID from the Auto Attendant WHILE the call is RINGING? Thanks.

1043: You said ACS R6 and Messaging R6 will support this, correct? The CID will appear while the call is ringing?

I tested it today, but the CID is only being passed AFTER the call is aneswered; during the ringing it says Voice Messaging System on the display. Will a move to Partner Messaging R6 with ACS R5.0 resolve this? My customer would like to know. Thanks.