Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SV8300 IP Phones Caller ID on 2nd appearance
- Thread starter refted
- Start date
belevedere
Instructor
Try placing a CID button on a line key. Press it when the second call rings in.
- Thread starter
- #4
This feature became available in Release 3.5 / D2 software
1369 Provide Calling Number Display for the 0 To provide
My Line when an incoming call is terminated to the Sub Line of Multiline Termi- 1 Not provided
nal
[8300R3.5]
It is on page 3-192 of the SV8300 Command Manual, issue 9.1
Below is from the 3.5 Release Notes document:
Enhanced Features
Caller ID Sub-Line
This enhancement provides caller ID on the LCD of DT300/700 display terminals on
ringing and call termination to a sub-line. The same sub-line can appear on hundreds of
phones and displays the CID Name and Number to all terminals at the same time.
Caller ID Display is automatically provided on ringing and call termination, no manual
operation is required.
1369 Provide Calling Number Display for the 0 To provide
My Line when an incoming call is terminated to the Sub Line of Multiline Termi- 1 Not provided
nal
[8300R3.5]
It is on page 3-192 of the SV8300 Command Manual, issue 9.1
Below is from the 3.5 Release Notes document:
Enhanced Features
Caller ID Sub-Line
This enhancement provides caller ID on the LCD of DT300/700 display terminals on
ringing and call termination to a sub-line. The same sub-line can appear on hundreds of
phones and displays the CID Name and Number to all terminals at the same time.
Caller ID Display is automatically provided on ringing and call termination, no manual
operation is required.
- Status
