Recent content by oldfree

Hi guys, Who can disable to ring over USB headset but ring on speakers and audio using USB headset? users complaint about it because sometimes they don't want to take over headset. have a good day

list measurements trunk-group summary yesterday-peak

Thank you very much guys, I'll fix this issue with service provider :)

I can send config to you tlpeter.

Yes LAN1 is 10.10.10.10 I tried before that and i configured ip route.

My ARS : N; Dial N"@212.252.48.5" SIP OUTGOING ID I'm sure I haven't used 10.10.10.10 address any configuration except LAN 1 settings :) I think Service provider can fix this issue. Because I have a other custom with same provider(System 6.0). Traces likes 7.0's trace.

yes I used but It did't work. I tried all network topology settings. I couldn't change "Via: SIP/2.0/UDP 10.10.10.10:5060" to real ip. When I downgraded the system to 5.0.22 it worked.

Hi all, I upgraded the system 5.0.22 to 7.0.22. My sip trunk not working now. I traced SIP calls. and I found a problem. please check the trace to listed bellow OVER 5.0.22 (WORKING FINE) 246108mS Sip: 18.1067.0 21 SIPTrunk Endpoint(f51c27c4) received CMSetup 246110mS SIP Call Tx: 18...

Hi all, I upgraded phones release 3. IPO 500V2 and phones 1403,1408 models. My problem is "Phones want to upgrade again when I reboots to IPO 500". Any idea?

Hi all, I have problem with voice recording. have you ever seen this problem. System: IPO V2 6.1 or IPO V1 6.08 I tried two SIP provider. Voice recording: auto mode This is very annoying problem. when user call outbound over SIP Trunk with voice recording, I listen the record of call and...

hello friends, I have to problems on one site about CCR Agents. System IPO 500 V1 6.0.14 (Before this version i tried any old version) CCR 1.2.5.1 1608 IP Phones Voice Mail Pro, Contact Store etc. There are 30 CCR agents. Supervisor send Agent Summary Report for whole day. First problem...

Thank you for all TL I am using "inhibit Off-switch Forward/Transfer" so user can't forward phone his cell or other extarnal calls for now. Regards

yes

Thank you for your concern Don't worry :) I have a license But no change. :(

I tried "opstat" before but didn't work. Button programing : User can change buttons If user uses the features-phone user-Self Administer so IPO manager button programing don't help this. I'll try "system phone rights" after upgrade 6.0(8)