Recent content by nortelrob

Below is thd DCH INFORMATION ADAN DCH 3 CTYP TMDI CARD 03 PORT 1 DES SBC USR PRI DCHL 3 OTBF 64 PARM RS232 DTE DRAT 64KC CLOK EXT IFC NI2 ISDN_MCNT 300 CLID OPT0 CO_TYPE ATT SIDE USR CNEG 1 RLS ID 1 RCAP COLP MBGA NO OVLR NO OVLS NO T310...

IK have a CS1000 where when a caller calls in the call has to be put on hold for the caller ID information to display. It happens 98 percent of the time. Any ideas???

so if package 150 is there the customer can start programming 6 digit extensions or is the software changes necessary?

I have a question posed to me about making rollover exts.6 digit and leaving the PDN as 4 digit. Can anyone tell me where to look for this in the PBX what maybe needed to make this happen.

I have seen this posted before but with no real answer. I'm getting and SEC116 error when logging in. It tells me that the user name is logging in with a emergency account. The user name and login is one that we been using for quite sometime and now were getting this error. I have someone...

ADAN DCH 6 CTYP TMDI N 026 0 00 03 TYPE 3904 CDEN 8D CUST 0 FDN 3091 TGAR 1 LDN NO NCOS 5 SGRP 0 RNPG 10 SCI 0 SSU LNRS 16 XLST CLS CTD FBD WTA LPR PUA MTA FND HTA TDD HFA GRLD CRPD STSD MWA LMPN RMMD SMWD AAD IMD XHD IRD NID OLD VCE DRG1 POD DSX VMD CMSD...

I believe its been going on for sometime...Yes TDD is on all the sets the RCAP is COLP

Its swystem wide and on external calls only.

I have an issue where system wide the users are not getting CPND to there sets on incoming calls unless the answer the phone and place the call on hold...Anyone have any idea??

I'm using a US ROBITICS MODEM and dialing in using PROCOM.

I'm going in thru the core modem.cslogin dont work.

I'm working an issue where I need to pull some information from the cores.On RLS.6.0 how do you log into the cores??

Can anyone help me with a password issue. I have a call pilot system no one can tell me the release.I have tried all the NORTEL distributor and maintenance passwords with no result. Is the anyother or newer passwords NORTEL uses on the new release software? If so can you help??

Still trying to get this REGISTERED. This is a screen shot of what I get from the MGC. Still trying to figure out where I made the mistake. FPGA VERSION is 41413132 AA12 MGC GOLD Image MGCCAD41 Wednesday December 05 2007 12:44:33 EST Failed to read Tlan IP address information from bootline...

superloop is configured i believe i have populated the IP on the mgc it says something about elan not configured and it gives an ip address the ip adress is the address i gave for the elan for the mgc card.