Recent content by njd3vil

IP Office Server Edition R10.1 SP1 Reading through the docs and KB, it looks like there is no way for an External Party to dial into a scheduled conference if you un check the Auto-Invite box. Is this the case or have I missed something?

If you do run on Windows 10 and disable Windows updates, make sure that the pc does not get group policy updates that may re-enable Windows Updates.

I have tested this on 9.1.12. It's just a visual voice button. No MWI.

The best you can do is Visual Voicemail. It's pretty simple. Press the Message Button, enter password if applicable, and look at the screen. The first mailbox is the user, and the mailboxes below can be other users or groups provided the Source Numbers have been programmed. One-X Portal may...

You can add a time condition in the queued and still queued start points. However this is bad practice will most likely have customers upset more than anything.

Which sites have which version of 9.1?

Are you seeing the calls recording in system status?

Be careful using a PBX for emergency paging in schools. Not saying you cannot or shouldn't but phones end up unplugged, on DND, volume turned down low, etc..... Schools really need a stand alone PA system for EMERGENCY announcements.

Thank you. I feel semi embarrassed for even posting the question in the first place. However if something odd with the IP Office can be done, this place has some of if not the best engineers around.

You need to be at 10.0.2 or higher for the J129 to work.

I have found the 96XX Ports to be very fragile. Using patch cords without the anti-snag boots seem to help.

Xima Chronicall will give you everything you are requesting. You will need the following: Base License of Chronicall With Standard Reports RealTime Agent Seat License for each user you want to monitor. RealTime Agent Dashboard Seat for each user you want to monitor. Agent Dashboard will allow...

I received a request by a client asking that manually dialed outbound calls be disconnected after 8 rings if the called party doesn't answer. I have searched through the docs and did not see anything. Just throwing this out here to see if anyone has run into this before. Thank you

If you have an available DID you can create an "Special AA" with options that point to the short codes for the recordings. You can secure this by only allowing certain numbers access to it. This can be done using the CLI field in the Incoming Call Route.

You can use a short code for this. It is in the docs. Allows a user to change their login code. The login code must meet the Login Code Complexity requirements defined on the Manager System | Telephony tab. Details Telephone Number: The user's current and new log in codes separated by a *...