Please tell me which site is offering practice test for 642-902. I have used www.how2pass.com in the past for my CCNA, but 642-902 is yet to be available in the web site www.how2pass.com. If any of you have already taken the exam please let me know which website u have used to practice.
Thanks...
Hello Friends,
I have a question on configuring two bootprelays for two different DHCP servers that reside on two different VLANs for example: DHCP server 1 on VLAN X, DHCP server 2 on VLAN Y. There are two set of clients one set of clients residing in VLAN A needs to use DHCP serever 1 in...
Hi,
Can some one help me with congestion control on ethernet frames. How can I discard the frames when there is a congestions. Voice traffic shouldn't be dropped, but the data traffic can be dropped. On a layer 3 we have DSCP markings.
Thanks,
Neto
Hi,
Can some one help me with congestion control on ethernet frames. How can I discard the frames when there is a congestions. Voice traffic shouldn't be dropped, but the data traffic can be dropped. On a layer 3 we have DSCP markings.
Thanks,
Neto
Hi Geeks,
Its a simple ques?, but I don't know the answer. Why do we need a native VLAN on a trunk other than specifying the port as Trunk mode.
Neto...!!
It looks like your default gateway is not in the same subnet. You will have to make sure that 192.168.1.1 is in the same VLAN subnet as VLAN 2 for the Extreme to route the traffic.
I go with ExtremeTek, you need to enable IP forwarding in both the VLAN's.
Or change the IP address of your...
Hi Guys's,
For a Classless IP for example 192.168.0.0/27, the assigned IP addressess would be from 192.168.0.0 to 192.168.0.31 . Since 192.168.0.0 is a subnet IP address, I know we can't use it to assign any host with that IP. How about the last IP in the subnet 192.168.0.31, is there any...
Thanks,
The differnce in hardware b/w the ethernet and fast ethernet would only be in the TX and RX or even there is change in the physical medium. If there is a difference in the physical medium what is that !!
Neto...!!!
"you are running fast to remain in the same place
Thanks for the info,
Here I have a scenario were we have created VLAN's for routing the traffic on Extreme 48Si. But all these VLAN's use the IP address. IP address can be resolved only at Level 3 and VLAN's can be resolved at Level 2. I am getting confused here, since the switch needs to do...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.