Recent content by nbfd731

Ran into this article a couple of month ago about 911 and PBX's thought it was interesting Texas Senate Bill 788 was signed into law in May of 2015 requiring direct dial access of 9-1-1 from all multi-line telephone systems Here is the current link I found on this issue that appears to be...

Sorry looking through the post i did not give you your due. Here is your star. That was the issue ACSS SME

i would default the PVM card Start from scratch If it continues replace it ACSS SME

Morning Merlin System /Pri issue Switch type: DMS100 Prov: AT&T Dial Plan: 4 digits Issue: Customer wants everyone personal DID to send originating caller DID # not there main # Provider is allowing PBX to send # PBX will send main #...

I know there a patch coming out in sometime Aug for soft console I have run into many issue with 9.1 softconsole ACSS SME

Upgrade the firmware 9.0.6. There were a couple of reason for the segmentiation violation in your current release. Avaya was not clear on the cause. When u see addr=00000000 In the beginning string sending it to avaya they will only tell upgrade. They cannot find a root cause to that string...

I like the PDF too!!!!! ACSS SME

Should be able to relay with windows IIS ACSS SME

Do you see the reg request in system monitor. Discovery ussally means it dose not see the ip office. I do not know if u did. I would have clear the phone and vaules and reloaded all setting prior to setting it up on the ipo as well ACSS SME

I think might help The Send Caller ID parameter is set to “Diversion Header”. With this setting and the related configuration. IP Office will include the Diversion Header for calls that are directed via Mobile Twinning out the SIP Line to Verizon. The Diversion Header will contain the number...

Are these sites part of a SCN If it does then you should be using only one One X server not two. 2 is not supported. If there is a scn set the oneX to discover both ipo the my buddy IM will work. ACSS SME

Though i have not seen the issue. Have u confirm the firmware for the M-ata. There are firmware bugs that they put out patches for on there support site ACSS SME

Mac table resets and the phone sit in discover till the phones are rebooted to reestablish to the network. Im guessing ACSS SME

I had a customer where the pbx switch type was set for NI2 but the provider was set for Ni 1. This would cause thr B channel to drop and they would need to reboot the IPO 2-3 week. The D link never did just the B. It would always need a reboot to temp repair. I would run monitor noromal pri...

If you upgrade the expansion sd locally default the security settings first ACSS SME