Recent content by mszodiac

Hi Everyone. I'd like to thank you for taking the time to read this post! I'm working on a CS1000 release 7.5 Call Server and MGC cards that point to the backup security domain IP address. Can I simply run the command "unregister ucmsecurity system", then run "register ucmsecurity system" and...

I tried the password recovery but I get the error "Error: Cannot define device for /partition" Does anyone know why this is?

Thanks for your replies! I'm hesitant to reset the root password because the NTP says the BIOS must be a minimum 18 or it can crash the system AND I've crashed a system before doing this. It's really a catch 22 since. I do not know the root password and cannot run the command to confirm the...

I've tried deleting the files using admin2. However, if I show the permissions on the directories, it shows "rw --r nortel" only. I'm confused because as far as I know, nortel account was removed from Release 7.5.

Hello everyone! Our CS1000's signaling server's /var directory is at 100% full. Being at 100% full, we've seen our VoIP calls go down unexpectedly, and Element Manager becoming unresponsive. We do not have the root password (unfortunately). Is there another way to clear/delete files off of...

I fixed the problem. As per the help files, Remove Database Lock File can be clicked under the configuration menu. What I learned though is that the option is only available when you highlight Customer 0 on the ESN window of the PBX. Of course this is only helpful if you know the PBX you...

Yes I have. The was the first thing I tried.

Hello everyone, We still use the Nortel CS1000 Telephony Manager - Release 4.0 to maintain very few of our remaining Nortel's. Just recently, we haven't been able to make any database changes/updates. When I click on "Synchronize" either Transmit or Receive, I get the pop up window "The ESN...

Thanks bhassell2000. You're absolutely right! There were TNs remaining loop 2. I got fooled by the labeling though the TN was pretty obvious! I deleted the TN, and was able to delete the loop. TKTP COT ROUT 1 DES TN 002 19 MBER 1 COT IAO TN 002 20 MBER 2 COT IAO TN 002 21 MBER 3...

Hi Everyone, We've recently converted a remote site from DTI2 to PRI2. It's an Option 11 running 3.5 -yes it old :), but will be upgraded soon. I'm doing the clean up, but I cannot remove the DTI2 from CEQU. Here's what I've done: -disable loop (loop 2) -remove TNs -remove route From LD 17...

Thank you everyone for your input. I will setup a maintenance window and do a sysload on both the active and inactive side.

Yes, I can talk to the secondary CPPM card no problem. It is active. It is the redundant card so all I get is the redundant message on the serial port: HIRM: Inactive Redundant Mode Performing Background Tests ...

@tacosoup. We have a CPPM card. There's no window on it.

Hi Everyone, I'm hoping someone here as come across this particular system. We have a CS1000 HA system running 7.5. We haven't had any redundancy for the last few months. The HSP is the issue I think, BUT specifically, it is the LCS. Here's the output. ld 137 CIOD000 .stat hsp LCS HSP...