Recent content by MaxEMEA

You'll have to re-install the license and Auth files and they can be downloaded from RFA. With regard to support from Avaya....are they paying for support after 17:00/ If so, you'll get it.

You can change it whenever but the info in the NR only gets downloaded to the phone on registration. So, you'll have to re-register the phones.

Either the system is doing something else and you'll have to wait or you have corruption. If it's corruption you'll have to raise a case with Avaya to clear it.

What do these two options in 'display sys cust' say? Maximum TN2602 Boards with 80 VoIP Channels: Maximum TN2602 Boards with 320 VoIP Channels: This is your licence. If you aint paid for 320 channels you aint getting them.

07:10:34 Setup digits 0218224000 07:10:34 Calling Number & Name NO-CPNumber testdci 07:10:37 denial event 1220: Recovery on timer expiry D1=0x1a D2=0x66 There is a 3 second difference between the SETUP that goes out and the denial event 'Recovery on timer expiry' Looks like we...

I guess you found the answer already but you need a patch.

Victor, Check your 'Dialplan Parameters'as this is where you set how the system displays numbers to the phones. I'm not sure what you mean by inserting the 9 and the 1 on the trunk group? If it's to allow the phone to insert the 9 etc when calling out via the call log then this is done using...

I think your teacher is confused with 'Telnet'. Telnet uses port 23 and is not secure and anything you type can be seen in a sniffer trace. Ie, password's etc. In CM4 telnet is disabled by default and you must SSH to CM. It's ok to use the S8300 as a TFTP server for upgrades.

MM uses the QSIG DL2 (Divert Leg Info 2)message to decide what the correct mailbox is and where it came from. Either CM is sending the wrong info or MM is not reading the DL2 message properly. Do you have a trace of a bad call?

What is the port number you are trying to add?

Yes, but you need 'root' level access.

I think a 'show network stat' on the IPSI will display the MAC address.

You must set the Speed, Duplex, Negotiation in that order. 1. Set port speed 1 100MB 2. Set port duplex 1 FULL 3. set port negotiation 1 disable Actually, you may be able to swap 1 & 2 around but doing it this way has ALWAYS worked for me using FW36 on various Hardware versions. Please let me...

dwalin, AsafS, If you have a case with Avaya ask your case manager to look up: QQ:111809 (Tier III will have to do this)or look at MR:g3v2060575. There is no number for the G700 firmware yet as it has not yet passed Software Verification. If you give me your case numbers I'll speak with your...

Dwalin, Yes, it's a G700 firmware issue. Basically what happens is that the ALAW companding message sporadically fails to make it to the MM when the gateway reboots. Are you an avaya associate?