Recent content by Kodaker

Thanks, I'll try it!

Tried changing FROA to no....Did not fix problem...any other ideas?

Thanks I will try and let you know

Hi Everyone I have a problems with a Call Centre Q... The RAN Message repeats two times... I just want it to repeat Once....If I change it to 2 I get messages 4 times before I get Music.....See following the Interalia works fine .....We have tried to re-record still same problem, TYPE ACD...

we are setting up many networked PBX I have several numbers that conflict with numbers on the network. For example 72 is the paging access code in one switch, but I need 72xx in another switch. is there any way to set up *72 or #72 as an access code. I know that * is a feature code set up in LD...

Hello, I have call pilot 4 with Cs1000 Meridian, have licenses for Fax What I want to do is to use same dn for Fax and Voice... Can someone give some ideas how to do this? Or where I can find Info!

thanks....the system has only 8 sets...

Hello, new to BCM. I have an existing BCM 50 ver 1.00.2.04.j Customer has 4 digit 2221,2222, etc) ext now wants 2 digit ext such as 21,22,etc is it just a matter of changing it to 2 digit or does the system have to be restarted from new....don't want to try b4 is know what I need to do...

Has anyone had any experience with Reach Line card (16 Port) using Internet service provider to extend to remote locations? My system works fine withing the Company's infrastucture.. I have an application where I need to extend Nortel digital phones (2616) to several users in different...

Here is the configuration of one of the sets But I'm sure gwebster is correct... I have a hosted Voip system and it's the same but is there a way to get Name to show first instead of number DES 537 TN 252 0 15 31 VIRTUAL TYPE 1120 CDEN 8D CTYP XDLC CUST 0 NUID NHTN CFG_ZONE 011...

Currently running rls 5.0 on a cs1000e. When an inbound call is presented to an 1120ip set, the display shows the number on screen. To view the name display of the inbound call you have to press the arrow that appears. Can the display be reversed so the name appears first on the set display??

Hi everyone I'm installing a new Octel 350 on a 81c I'm looking for the CONNECTION information to the network to be able to do telnet sessions for remote access... I've scanned through the Docs...I know I need a uds 10 or uds 100..I have one of each....Does it connect to the 1st ENET...

Hi everyone I'm installing a new Octel 350 on a 81c I'm looking for the connection information to the network to be able to do telnet sessions to access remotely... I've scanned through the Docs...I know I need a uds 10 or uds 100..I have one of each....Does it connect to the 1st ENET...

Thanks for all the replies...Have been out of country Sorry I did not give all info The reason for the parallel reload is the following...

I'm looking for the specs on how to do a parallel reload on Opt 81c cpp processor.... If some one has a quick document it would be appreciated