Hello,I moved a Nortel 0/32 with a call pilot 100, after the move the call pilot does not answer in night service or at all.
Can someone give me an idea how to fix? Thank You
I think you are right maybe you should bow out, reading these questions thoroughly is half the battle. I mentioned the original NAM was a 4.1 twice.
Maybe you might want to come down from your high horse and stop berating people as to their knowledge.
Thanks anyway
If you read my second post I stated the original NAM was 4.1.
If I could have gotten hold of a 4.1 I would have, I needed it fast.
For the most part I do know what I am doing and I did ask about this and was advised incorrectly.
That's why I tried here, but you still did not answer my question...
The NAM I replaced was a 4.1, maybe the problem is I restored to a 4.0?
Maybe if I get a 4.1 and restore the data to it, it will work?
Should't the 4.1 already have redirect DN in it?
Thanks
I replaced a NAM on 0x32 and installed the data from backup disks to the replacement NAM and all data seems to be there.
Now when you call in and the attendant transfers the call to an extension the phone rings 4 times and then the main greeting plays if the call is not answered and does
not go...
Thanks for the reply, after I posted this I realized how the paging issue could be resolved.
The carrier, AT&T told the customer that they could not do that because the lines were analog POTS lines?
I will investigate further about lines, just wanted to make sure that the MICS wasn't able to...
MiCS 0x32 5.0, is there any way with this software and POTS lines to enable outbound caller ID to display their main number from all lines that the users call from?
Also, is there any way to have certain areas receive pages through the phone only under specific circumstances and not hear the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.