Recent content by kce9751

Awesome...thanks KCFLHRC. I did that and I can see exactly what I'm sending so the carrier will need to do some proving now.

Right, which is why I reposted it. I think it is the carrier overriding the settings. Ill check it. Thanks. If anyone has anything else on it, let me know.

ENTRY 5 HNTN 412 <==== Here is the area code ESA_HLCL ESA_INHN NO ESA_APDN YES HLCL 644 <===== Here is the NXX DIDN YES HLOC LSC

ENTRY 5 HNTN 412 ESA_HLCL ESA_INHN NO ESA_APDN YES HLCL 644 DIDN YES HLOC LSC Here it is. I should have printed the CLID. Its the main billing number that keeps showing up.

Hello All, I am trying to send out the individual numbers instead of the main billing number. I have defined the following CLID and assigned it to the phone: CLID yes SIZE INTL ENTRY 5 HNTN ESA_HLCL ESA_INHN ESA_APDN YES HLCL 644 DIDN yes HLOC LSC...

Here is the extension 4923 REQ: prt TYPE: tnb TN 20 0 15 5 DATE PAGE DES DES FRANK TN 020 0 15 05 TYPE 2616 CDEN 8D CTYP XDLC CUST 0 AOM 0 FDN 4444 TGAR 8 LDN NO NCOS 7 SGRP 0 RNPG 999 SCI 0 SSU XLST SCPW CLS CTD FBD WTA LPR PUA MTD FNA HTA ADD HFA MWA LMPN RMMD SMWD AAD IMD XHD...

This is a older version of 25.40B. A few weeks ago x4923 and x4500 were swapped. The hardware was swapped and the programming. Afterwards, their boss complained that she can not see when they are on the phone. So I deleted and readded a BFS key to her phone. She has a add on module. However...

Hello, I have a CS1000E that has a misp cards and uilc cards. Calls can be made and otherwise the phone is working but it does not get dial tone. Does this require DTRs perhaps? Any help would be greatly appreciated.

Yes I do.

Hello, The MWI light will not light on 2500 analog sets on this cS1000m mg rls6.0 machine. I do not see patches related to this. Any ideas on this would be helpful. Kim

I am upgrading to release 6.0. When I enter the compact flash that I created, I get "remove disks or other media press any key to restart". Even if I remove my compact flash I get that same error. Anyone seen this issue? HELP!!!!!!!

CS1000 SG (Opt 61) Release 5.0 Up to date on patches Hello, I'm working on an install and I'm trying to figure out why the high speed link will not come up. The carrier comes up at 100MB Full. I have rebooted so many times both cores. I've replaced the cable, reseated the pentium cards...

Thanks wane. That's definitely worth a try. I'll frog the controller cards.

Yes, I've done that and the controller does not come up because the loop is disabled.

Hello, I am working on a new install. I have 2 IPE shelves. One IPE shelve is split between two different superloops.(8-1 and 28-0..2 segments each). The other IPE shelve is 28-1 with 4 segments. I am unable to enable superloop 28 with the enll command or enls, I receive NPR327. I've...