Recent content by jacabuk

1 type of cabinet 2. type of phone 5 10 20 30 button phone 3. three pair jumper wire helps. Can help you with wiring the different phones

BCM I have a BCM where different extensions on different cards keep rebooting and coming back up. need some advice on what to look at

thanks, i found out that a sip gateway won't show if is registered or not. i turned on dch messaging and determined a problem with their server

How do i check that? i don't remember

yes it is. this is a sip route where all the other endpoints are working except this one

I have an endpoint which is a server. when i call the five digit extension to reach the server, I get a fast busy. i can ping the far end server. i checked the logs for the NRS server and i have repeating Internal process flow through provisioning engine is disabled. Is this error related...

I just had a Cisco 3400E series router installed which is tied to a Adtran 908e. I am trying to interface two PRI's with dch's. The PRI's come up, but I am receiving non-stop receive errors (slipr) Has anybody experienced this scenario and have a solution. This is a cs1000m rls5

I have a question as to why all of my ip sets are registered to the follower and not to the leader ss. both of the ss are up. if the leader did go down, but came back up, i think the sets should have registered back to the leader?. this is a cs1000m release 5. can anyone give me any advice...

Hey' I need to load desktop messaging on a users pc. I am looking for the cd. what is on the face of the cd for call pilot 5.0 Thanks

Is windows 2003 still supported, I thought I saw somewhere that it wasn't

Is the system properly grounded, you might be getting some foreign interference from somewhere.

Is this a virtual office phone? if it is, it could have something to do with e911 service. Look for package 336.

Thanks, i will try this and see what happens

Is your system grounded? The display 2xxx phones will pick up static electricity and go bad. The only way to clear a bad display is to, unplug and replug the phone. Just a thought

I need some help programming ESA in load 24. i would like to show it activated on a tty port as well as show the information to the 2250 console. cs1000 rls 6. the end user dials 9911 and pri trunks show 10 digit main number I am not sure what to enter for the following prompts; ent 0 ddgt...