I have an endpoint which is a server. when i call the five digit extension to reach the server, I get a fast busy. i can ping the far end server. i checked the logs for the NRS server and i have repeating Internal process flow through provisioning engine is disabled. Is this error related...
I just had a Cisco 3400E series router installed which is tied to a Adtran 908e. I am trying to interface two PRI's with dch's. The PRI's come up, but I am receiving non-stop receive errors (slipr) Has anybody experienced this scenario and have a solution. This is a cs1000m rls5
I have a question as to why all of my ip sets are registered to the follower and not to the leader ss. both of the ss are up. if the leader did go down, but came back up, i think the sets should have registered back to the leader?. this is a cs1000m release 5. can anyone give me any advice...
Is your system grounded? The display 2xxx phones will pick up static electricity and go bad. The only way to clear a bad display is to, unplug and replug the phone. Just a thought
I need some help programming ESA in load 24. i would like to show it activated on a tty port as well as show the information to the 2250 console. cs1000 rls 6. the end user dials 9911 and pri trunks show 10 digit main number
I am not sure what to enter for the following prompts;
ent 0
ddgt...
I am confused on what to enter in these fields. the user must dial 9911 to activate, and i need the main number sent which it already does. i would also like the operator (2250 console) to be activated.
ld 24
new esa
ent 0
ddgt?
dfcl?
esdn?
osdn?
Thanks
Someone told me that they were at a customer site on day and while looking at the system terminal a user initiated a 911 call and it showed up on the screen. .does anyone know how this is set up. i would like to look a the history file and see who dialed 911
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.