Thanks everyone for the great suggestions!
After reading over the configs and looking at manuals, I asked the tech to recreate the h323 trunk and it worked after that!
They said they had already rebooted it before..
I'm just glad its working. So recreating the trunk fixed the problem.
it's a site to site vpn. Nothing is in the way. Switch > ASA > router > MPLS CLOUD > router > pix > router >switch
the VPN should by pass it all.
is there a way to "reset" the SCN on the remote site?
The remote site is running an IP Office 500 V2 with release 6.1.20 on it and the HQ site is running an IP Office 406 V2 with release 6.1.12 on it.
It is working on the other sites connected to the HQ
I'm asking the tech to confirm but under license it says IP500 Voice Networking Channels
Available 4
In use 0
Valid
It helps to say, apparently it was working for a day then over the weekend it no longer worked. They restarted the ASA but the config looks like it is supposed to look.
The VPN...
Thanks kwing
I tried that but still shows down.
I can ping back and forth and a port scan shows onlly 80 443 1720 and 5060 open on both sides. Even when I scan locally.
policy-map global_policy
class inspection_default
inspect dns migrated_dns_map_1
inspect ftp
inspect rsh
inspect...
I'm not very familar with Avaya phone systems but an Avaya tech is telling me that my firewall is filtering the traffic thus the SCN is showing down in the system status.
This is a site to site VPN. The system status on one end shows that the remote end is DOWN. There is no filtering in place...
I have a problem but can't figure it out. Calls going outbound are not working. I get a fast busy and the following debug:
*Jul 13 15:10:41.926: //-1/80464D2D3500/DPM/dpAssociateIncomingPeerCore:
Calling Number=3615555555, Called Number=919567777777, Voice-Interface=0x0,
Timeout=TRUE...
sorry missed that.
what does:
"show ip dhcp bindings" show?
There are many possibilities including a DHCP DoS attack. Make sure one of your clients isn't taking up multiple addresses.
whykap,
I justed figured it out. I used the following as a guide:
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml
I tried using cor but it was not working properly. It seemed as if the COR restrictions were ignored. The config used this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.