Call Routing with Dial-Peers and H323 Gateway

[ifoam]

http://pastebin.com/TvHQwuk2

There is my config.

I'm trying to configure this gateway so that only calls coming from extension 1258 will use dial-peers 500 and 501. Calls from any other extension will use dial-peer 100-103.

Right now, it seems like it doesn't matter that the calling number is, the same dial-peers are matched regardless.

Can anyone help?

 

[whykap]

Don't you have call manager? Change to mgcp and make it a lot easier on your self.
Are your FXS ports for the faxes on the same gw? if so put them in the same cor and try again.

 

[ifoam]

whykap,

I justed figured it out. I used the following as a guide:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml

I tried using cor but it was not working properly. It seemed as if the COR restrictions were ignored. The config used this:

dial-peer cor custom
name restricted-pt
name unrestricted-pt
!
!
dial-peer cor list restricted-css
member restricted-pt
!
dial-peer cor list unrestricted-css
member unrestricted-pt
!
!
dial-peer voice 8312 voip
corlist incoming restricted-css
answer-address 8312
!
!
dial-peer v 911 pots
corlist outgoing restricted-css
destination-pattern 911
forward-digits all
port 3/0/0
!
dial-peer v 9911 pots
corlist outgoing restricted-css
destination-pattern 9911
forward-digits all
port 3/0/0
!
dial-peer v 7 pots
corlist outgoing restricted-css
destination-pattern 9[2-9]......
forward-digits all
port 3/0/0
!
dial-peer v 11 pots
corlist outgoing restricted-css
destination-pattern 91[2-9]..[2-9]......
forward-digits all
port 3/0/0