Recent content by idahomitel

Wake-up call?

Form 19? Call re-routing.

I'm clear at the bottom. Could you be more specific? 280 shows device interconnection table.

Thank you for your continued help!

Erased the phone and re-programmed as a 5312 bare bones. Now it has no MAC address nor does it show having an IP address, but it rings and is idle now!?

I wonder, if I erase the extension and re-program it, will it be assigned a new DHCP address that I could then change remotely to static and permanent?

Thanks, I will give that a shot!

SX-200 ICP, and I don't think MDUG applies, thanks.

I have a 5312 set that has been replaced twice, and is locked. Have released it in maint, but after answering call, reverts to locked status.

Went in through the phone, edited mailbox 0, gave it a new password, changed the extension back to 0, (had it going to ext 550 sub att because it has a generic greeting for the hotel. Problem mailbox is now deleted, bit when getting transferred to voice mail from a phone, I still get the name...

Checked, and no, as far as form 19 goes.

By done I mean checked. That's the way it was/is set. Form 19 nothing unusual, just set for LDN keys. I'll try again to listen to the "0" name. Seems like that wasn't an option, nor is deleting it and re-programming it.

Yes, there is a call staus in maintenance. By extension, trunk, software id, and show status all. Call shows ringing extension, then goes to idle after it forwards, doesn't show where it forwards to, however, but it forwards to operator mailbox, even though it says the GM's name.

Done. "0" is transfer only, and the extension is "0".

All overseas area codes are denied, I have the list. Calls are not going off-site, Dial "0" calls are getting the actual GM's mailbox name.