Recent content by Highlights

Yes I did a F903 and it kept saying: Starting StarTalk Flash Access/2 !! Tel wait for Functerm !! Tel wait for Functerm !! Tel wait for Functerm !! Tel wait for Functerm Please Check The KSU ports!!! Base Alarm 014: Could not start Access2. Rebooting. 2.0 says HALT and then says the SW is...

Yes thank you both. I think the 2.0 is bad I get an error when I boot up on the Hypertermianl display while I monitored it. I did a complete **STARTUP a few times still only worked with the lower versions. This system only uses 2 mailboxes and no aut attendant so the Flash is just fine. I...

I thought that is might be a SW compatibility issue so I changed the CICS from 6.1 down to 2.0 and then the Flash 1.5 and Flash 1.7 came online. Do you know what SW version of Star talk Flash will work with a CICS or MICS 6.1 and above?

I ran into a problem getting the Flash to work. I tried it on a MICS 7.0, CICS 4.1 and CICS 6.1 and I plugged in a 25 pin cable to my hyper terminal and got these results. Version 2.0 would not boot up at all so I installed 1.5 and 1.7. I read several Threads and checked and rechecked the...

Yes Nortel seems to be built like a tank to bad Nortel the company is no longer around. I wonder what the product lines and legacy lines would have evolved into in 2017. These new IP based systems seem to be unstable and cause users more problems.

Yes it is a Star Talk Flash.

I tried to assign the lines to a set as suggested but I get an error that says: "PRI LINES CAN NOT BE ASSIGNED TO SETS

Will a Start Talk voice mail version 2.0 work on a MICS 6.0 or higher?

Thanks!

ON a BC50 system I am able to actually look at an active system status and see all 23 channels, calls in progress etc. Is there any way to see these stats on a MICS 7.1 XC so that I can tell if I am going to need another PRI? The only metrics I see are the Hunt Groups. I am mainly looking for...

Yes this change worked, thanks!

Thanks, System Status says DND is OFF. I am waiting to hear back from the USERS if the DND is actually working and the DND button is toggling ON and OFF.

Yes it does say "Apply User Rights value

Let m check

Thanks I am going to try these suggestions.