Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by eugeneatwork

  1. eugeneatwork

    Changing VGMC IP address

    Any suggestions what is the command for that? I can not telnet into the module as I do not have the Login/Password combination. By the way, how can I reset it?
  2. eugeneatwork

    Changing VGMC IP address

    Need to change 2 IP addresses on the MC-32 (VGMC) card: "Card IP" and "Leader IP". I guess, I can change the Leader IP from the IPL> prompt using "setLeader" command. What about Card IP? Can I change it without using OTM (don't have one)?
  3. eugeneatwork

    Dialing by Name on Option11

    Hi guys, Sorry - I am a bit late with response... Was putting other fires down :) And you are absolutely right - that was in Restrictions table, where number 6 was blocked. As soon as I removed it from there everything started working. Thank you for your help - that was great!!! I have more...
  4. eugeneatwork

    Dialing by Name on Option11

    Changing extension numbers from 8XXX to 6XXX and realized that I am loosing the ability to dial-by-name through the CallPilot. I did change extension numbers in LD11 (these are 3904 sets) and I changed them in the CallPilot using CallPilot web gui. Nothing else (CLS, CLND etc.) changes. Where...
  5. eugeneatwork

    Disabling D-Channel

    Thanks a lot, The only issue I am running into,- is when I go to LD 16 to reconfigure the trunk it does not allow to use NI2 on the ISA trunk. Do I have to change it to TIE?
  6. eugeneatwork

    Disabling D-Channel

    Hi ALL, Actually need help with 2 topics: 1. Getting BUG1369 errors when trying to dial-in to the new PRI on the Option 11c. Need to confirm that it is related to the wrong PRI type. The Option 11c has just being moved from Bell Canada (DMS-100) to AT&T (NI2). 2. While trying to change IFC to...
  7. eugeneatwork

    PRI-to-PRI traffic

    Thanks yyrkroon, The issue is that we are installing a new PBX and will apparently migrate to it (re-route PRI as suggested). But for the time-being (while moving the office) - I need to route traffic from one PBX to another.
  8. eugeneatwork

    PRI-to-PRI traffic

    Can someone remind me if traffic is allowed to cross from one PRI to another one on Option11 (two NTRB21AB cards)? I need to send all the traffic coming on one of our PRIs directly to the other PRI.

Part and Inventory Search

Back
Top