Hello guys!
Does anyone have success configuring the SIP Trunk with TLS and SRTP between MG100/300 and the SIP Provider?
I have a scenario here where the PBX and SIP Provider are failing in the handshake.
I tested it in another 3rd party PBX and it works. After the PBX received the certificate...
Hello LuigiEspo!
The command alarm -p -f detail can give you more details for each alarm. Also, you can see at /var/log/messages in each LIM to search for more information.
BR,
Edgar
BR,
Edgar
Hello!
Does anyone know if Mitel 6800i series SIP Phones can support RFC 2453 and "Use Outbound Proxy in Dialog"?
A customer has a 3rd party PBX that use this method to reproduce music-on-hold when a station put a call on hold or transfer calls. We have an example of Yealink SIP Phones working...
Hello!
In 2018 this thread thread1329-1783882 mention that 6900 phones with SIP firmware doesn't work with 3rd party SIP PBX. I never found the F.A.Q. document that mentions this. Is this information still valid?
6900 series cannot be used with 3rd party PBX?
BR,
Edgar
BR,
Edgar
I have a MX-ONE 5.0 SP8 system, with 6 LIMs/servers, and the HD of Server 3 "died'.
So, I replace the server and prepared it with new installation of MX-ONE files, to do a Repair Server procedure.
But, when I tried to do it, I'm receiving the following error message from SSH, and the procedure...
Hi all!
I found a thread here thread806-1724069 from 2014, about recovery BP250 password, and now I need to execute this procedure. I tried to found the files of the procedure, but the Dropbox link in the thread is broken.
Is there anyone that has the correct procedure and files to do it...
Hi martinhodge!
Yes, we have free VoIP channels enough in the system. We have a VOIB128 with 64 channels just to relay, and we have only 38 IP-DECTs in the system to use it, that is, we never used the top of capacity. We are using just PCMA codec with 20ms of packetization (in both eMG and...
Hi!
We are using the latest version of Unified SW, 3.5.17. But I have been this issue since we installed the system, in older versions, like 3.1.7.
Thanks.
BR,
Edgar
Hello friends
I'm having problems with iPECS IP-DECT system GDC-800Bi (O&M by RTX) connected with an iPECS eMG system. We deployed a MultiCell system with 14 base stations and 38 GDC-800H terminals in a factory, taking care of minimal signal strength between base stations to do "Air Sync"...
thread1613-1752381
I'm trying to register this kind of terminals such as described in this post:
https://www.tek-tips.com/viewthread.cfm?qid=1752381
But I'm not having success. The iPECS GDC600 is configured in the eMG80 system, and working fine with iPECS DECT terminals (GDC500H). But when I...
As I know, IP-DECTs are registered in iPECS UCP/eMG systems (Unified) as a SIP Phone, and iPECS UCP/eMG systems don't support callback feature in SIP Phones, unfortunately. But other than that, works well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.