Recent content by eddiephones

Anyone familiar with the C-6,M-8 caller ID units used in these systems thru Digital Ports? Can The M-8 be used on a 616 or can it only be used on a 8X24, and C-6 only be used on a 616???????

Dewey: you were right about the NAM (fiber) holding its program, all Greetings,MB's OK, except GD box was locked!The Power Ploblem was a 30-sec on/off surge.The company was using the AA greeting for answering calls, 221 (0) was assigned the GD box,and some other phones had ANS_DN's fromm 221...

Have a Customer with aNVM-(Fiber) Customer lost all power and when it came back, the Voice Mail does not answer with the AA greeting #1 (Morning,noon,night,& Non Bus) But goes directly to the General Delivery MB. Tried to duplicate in shop with another KSU & VM with no luck? Presenly I'm on my...

NOTE: You could try a seperate DC power supply (12 or 24VDC) with a DP or DPDT relay, connect the door strike contacts to the relay coil, then one side of the relay to the door strike & the the other side to your camera control & hopefully the camera will catch anyone going thru the door if the...

Silver 987: Thanks for the info on that REFURBSUPPLIES place,I was able to get the exact LCD replacement part I needed!

Most 7310,s are model NT8B20AF (horizontal input jacks) however I have a Model NT8B20AE (vertical input jacks) In this AE model the LCD is a seperate component connected by a Ribbon strip from the LCD to the PCB..Anyone out there know of a Nortel component parts place where I could purchase this...

Just like the "A" team! Don't you love it when a plan comes together! I just want everyone to know that using the Norstar Debug Procedure on site I was able to get the changed installer pswds for both the 8X24 & CICS Ksu's & changed them back to CONFIG: Kept all original programming What a great...

exsmogger: So its like putting in NAMES in the Voice mail & using the # to move digits! I had a DR-3 cartridge & changed the installer pswd to 123456. I then went into the Debug procedure and it showed me the new paswd 123456..This is a beautiful tool and I'm hoping this will work on the site of...

missedbythatmuch: I tried getting into the Norstar Debug procedure. I got as far as SHOW memory dump and when address came up on LCD it only allowed for one digit to be put in,and when i put in a digit & show nothing happened.

misseditbythatmuch: The DR-5 cartridge I have here,on the sleeve circuit board are Two(2) both 5.5V@1.5 Farad. Since the one I have is OK with Config,is it possible if the DR-5 on site is a 2-piece cartridge could I just put my sleeve in and maybe wind up with config pswd from my sleeve and keep...

exsmogger: Right on with LeaveMsg----Thanks

exsmogger: Do you mean the Cartridge itself,or the sleeve it fits into,saw nothing inside DR5 cartridge,but 2 round with black components marked C1 & C15 about the size of a nickel inside the Sleeve section! Also did you mean a momentary short with the resistor,or have it in place and power up?

Would like to know if its possible to send a caller in the CCR Tree using a single digit to a guest MB that is not a phone extention?

NOTE: Inherited a 8X24(DR-5) and a CICS systems...Able to get into ADMIN PROGRAM ONLY on both systems. Can not do SYSTEM STARTUP on either one? The installer password has been changed from the default 266344. Will changing software cartridges help? Any ideas about resetting both systems?

NOTE: I want to Thank everyone for their information about the Call Pilot 150, I was aware of many calls that the GD could store,but I didn't realize that hundreds could wind up there? Without someone checking I agree its a great place for Dial Tones & Please Hang up, anyway Thanks again.