Recent content by eddiebullman

Hi does any one have the NEC Sip firmware for the DT700 series phone thanks

it can be done but very complex to do one thing though your extensions on the asterisk server will need to be on a different number range from that used by the NEC. you will need to setup LCR on the NEC to route extension numbers on the new PBX via the PIR trunk which then needs to intercepted...

Hi if you look in PGM 101 you should have in the logical column numbers with XXXX(H.D) next to them this will be your hotdesk agents they can't have a physical phone associated to there number the phone that you are logging into phone be set to hotdesk in 111 / 23

The short answer is no there is no SIP firmware for them there used to be some LIP-88XX that had sip firmware available. This was answered in a previous post "IPECS LIP-9010 SIP Firmware

LG UCP is a great platform. hardware or software based now with V5 Only just started playing with 3CX which I am running on AWS but looks ok so far

LG UCP is a great platform. Only just started playing with 3CX which I am running on AWS but looks ok so far

Hi I am looking for a single port FXO devise to connect an analogue line to a 3CX system that is running on a VmWare ESXi server so I cant use a internal PCI card any recommendations Thanks Eddie

Hi We used to fit the LG WiFi phones (WIT400HE)and they are a pain i have tried one Ascom i62 handset and it did work with the draytek access points but not very well so we have fit IP DECT instead i have spoken to Pragma about getting Unifi access points certified with Ascom but they did...

Hi Have you tried putting the mac address in pgm235 and you have put the login details in pgm443 you could also put the mac address in pgm442 i am using an Konftel300Wx on the system that i am working on at the moment but it is registering direct to the iPECS D130 IP Dect base and shows up...

Hi i have an issue with incoming caller display in the UK if i receive a call form out side my local area or mobile the called display is missing the leading zero of the number e.g 7********* or 1508****** i can get round this in PGM151 setting "incoming Prefix Code insertion" to ON and...

Hi Do BT quantum 8568 phone work on a MiVoice 250 as they appear to be the same as Mitel 8568 thanks

Hi Hasan the first thing i would do is put trunks one to three in trunk group 1 and put trunk four in group 2 programing step 140 this way you can access trunks 1 to 3 by dialing 9 and trunk 4 by dialing 89002 by default you can set up LCR to router the call over different trunk groups but...

Hi Paul can you set them to Local but NO on the same Lan setting ?

Hi Paul as for the Zone stuff set remote site phones to local-remote and put them in a different Zone and set that Zone to Force Relay

Hi Paul If the system sees the handset in remote mode it will modify the sip packets to insert the IP that is set in the 102 & 132 (firewall address) as the address not the internal IP of the UCP or VIOM as it would need to do this to get remote handsets to work the local-remote setting...