Recent content by Deweyhumbolt

Probably nothing changed...I cannot guarantee I made a local call out a Nortel on Friday. The NXX RLI was 0! I changed my RLI for 0 to the same as RLI 10 and I'm a less heroic figure than on Friday, but at least positive. "Adversity is Opportunity

I made up a test RLI and applied to a specific NXX the calls go through. Here again, I can't go through and assign EVERY NXX to my RLI. What changed?? Thanks. "Adversity is Opportunity

All was well until they made some changes today. All calls were going across the Cisco Ties and I was a hero. They put the 2 PRIs back on the Nortel because the DIDs were not ringing in to the CCM. They found the CCM was set at NI2 and CenturyLink and the Nortel were at 5ESS. After taking the...

I don't want to effect the existing route 32 sending 4 digits, by prepending with a "9". So, for testing purposes I built a new RLI of 18 and pointed it to route 32 with a DMI of 18 that stripped nothing and added a "9". Then I went it to LD 90, went to the NPA 1714 (my cell) changed it's RLI to...

Thank you sir! In the meantime I made sure if I got the digits correct the call would actually go out the Cisco. I used my ACOD for the Cisco trunks and instead of dialing just the 4 digits, I dialed all 10. At 1st it did not go out, but after making a change on the CCM I can make LD calls...

We are migrating off our Option 81C and into a Cisco Call Manager. I use to have two PRIs direct to Option from outgoing calls. The Cisco has 2 PRIs also for outgoing calls. All the DIDs use to come in on the Option, then traverse the 4 tie lines to Cisco. Today we moved the two Option PRIs to...

I have 1400 built analog ports on my Option 81C. I'm charged with getting this info out of the Nortel and into a spreadsheet so that a script can be built to program Cisco VGs in order to cut over all analog ports. I know at least half these analog ports are old modems or telephones long ago...

I'm trying to delete 02, 03, and 04 from the TARG in the RDB. I just want TARG 01. How can I delete these restrictions and not effect anything else? Thanks!! "Adversity is Opportunity

Is this possible? I have an option 81C 4.5 at a VA hospital. All my dialers work fine, however they recently replaced a two-line dialer for the fire alarm and it intermittently fails to send the DTMF digits before the analog dial tone times out. Every time I monitor the DTMF leaves within 3 1/2...

I was looking for the easy was and a way they could not change. Thanks for the clue, I had to visit 10 telephones, no biggie. "Adversity is Opportunity

System version: 9.1.2.14900-14 Can I apply a distinctive ring to a DN and apply that DN to multiple models of Cisco VoIP (sccp) telephones. no matter their personal ring settings. This is like "Must-Answer" line, where it rings on 9 telephones with the same ring at the same time. Thanks in...

Is there a way to build (in Nortel would be called "Information Mailbox) so that only a greeting is given with out any chance to leave a message? Thanks. "Adversity is Opportunity

I'll be taking the CCNA Collaboration later this month in order to keep my CCNA Voice valid. You only have to take the 4 day video portion to renew. "Adversity is Opportunity

I've just realized the manual switch on the front of the clock controller card is set to "Disable" and the light is red? Does this mean all my clocking for both groups is on the other clock controller card? And, is there a foreseeable problem with turning it to enable? Thanks! "Adversity is...

I have moved 100 telephones all in the 54XX range from an off site location to our main site. I already changed the CSS, DP, and LOC for all 100 manually. Is there a way where I can bulk change all of the eleven individual CSS under Call Forwarding for all 100 telephones in an extension range...