Recent content by daniel26

What is the formula of calculating the handling time on CC6 symposium?? Is it only the talk time or it is the talk time in addition to the break time and ringing time?? Can someone help me. Thanks.

Each day at midnight, the cpu's are switched. on the new active CPU, the CNI is disabled. i notice the following error: **Warning attached group will be out of service** CNI0012 CNIP 0 12 1:Putting port into disabled mode. This error is generated several times when any CPU is becoming active...

Digital Trunks DTI2 go into LOCKOUT state, then TRK136 message is displayed.We have CS1000S 4.5 SYSTEM. Can someone help me. Thanks.

we have call pilot mini we want to upload a file music for recording. we need the password for user name :"tas" to FTP the file. Can someone help me. Thanks.

Dear gwebstr, Can u tell me the name of the option? Thanks.

we have a quality of service enable in a signaling server rls 4.0 and we have a network switch they don't have a quality of service where we should register a IP phone set. What should be do to register this ip phone without disable QOS in signaling server. Thanks.

Sometimes we obtained a pop up message on outlook :"task callpilot messaging receiving reported error (0x8004010F):the operation failed.An object could not be found." Can someone help me. Note: I have callpliot 201i release 3.00 Thanks.

We already installed this patch CP303S02G07S and we rebooted the server but we got same problem today from a user when he tried to hear his messages he got a one hour delay between the message and the real time. Any suggestions?

i am obliged to use HOTIX software. Thanks.

PMS Software.

How to connect HOTIX software with Nortel system option11c. Thanks.

Hi strmwalker, just if u can tell me if is a call server patch,signaling server patch or a call pilot patch and if u know the patch id can u send it to me please. Thanks.

We have a problem with the time of the callpilot 201i release 3.03.06. Some users complained that when they heard the message, it said that they received the message at 2:00 pm when it was still 1:20pm. Thanks.

When user take the speed call key he can dial any numbers without restriction, can i put some restriction.

Hello all, i've installed the option 61C but the cpu0 cannot boot and i got the following: KC: fail to retrieve data from keycodm file:"/p/install/keycode.rec" sys4597 read keycode file error. i reinstall the software and the keycode for the RMD but it did not solve the problem. any help...