Well the customer is just trying to re-load the base software. They were running 12.14 and something went wrong. They were sent a 12.11 install tape with the understanding that ANY 12.xx install tape would give them the base software they required.
I have a customer that was running MM12.14 and is now trying to load MM12.11 and is running into issues. I have always been told that you can use any 12. tape as long as you are running 12.xx software, meaning you can not use a 12.xx install on a system running 13.xx software.
Sorry for the...
I see a lot of the NTDW59's come through and even the NTDW61's and NTDW99's that have failed memory on them. Janaya is spot on saying most of the time it is memory failure, and memory is cheap..
I have a few IP 2033 Conference units running Unistim 2310S97 and I would like to upgrade them to 2310S99. I am using Pumpkin on a Windows 2013 server that works well to upgrade my 1140's and 1120's to the newest firmware. I manually configured the 2033 with the TFTP Server IP address, it boots...
Does anyone have a copy of the latest firmware package, or v1.40.62-0665? I have a 1006r here that I replaced the midplane in and the replacement has some outdated firmware.
Well I have tried to "Activate" windows both online and over their voice response system and I get the response "Not a valid product". Is there a certain vintage of 703t server that will only accept up to a certain release of CP? I am trying to load CP 4.0 on a NTUB06EA 703t server. I have done...
I have a couple 703t's here in my warehouse and when I do a fresh install of CP 4.0 I am getting the message "Must activate windows" after startup and logging into the system. This is the 1st time I have ever had a CP Server ask to activate windows. This is happening on different 703t's and even...
The firmware is loaded onto the SSC card then pushed to the phones, I am sure it all depends on the release of the CS1000 software, but I have all the releases so I am not concerned about that, I am just lacking these specific firmware releases for these phones. I am thinking 9.4 is fairly...
thread798-1732903
Hey guys,
I am looking for firmware for the M39xx sets. Particularly 9.4 for the M3904, 8.9 for the M3903, and 8.4 for the M3902.
Can anyone help me out?
Thanks in advance
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.