Recent content by carlsclan

Hi there. I need to set up NTP on a 4.1(3) cluster. I have tested this out using the usual MS setup on my test CCM however there seems to be a problem and its not syncing with the NTP source. Does anyone have any good recommendations for NTP on a CCM cluster? Cheers.

hi all, I am trying to add more ring tones to my 7912 as I only have the default chirp. I have looked @ http://www.cisco.com/application/pdf/en/us/guest/products/ps4153/c2001/ccmigration_09186a00801f011f.pdf and seen that you need to modify the ringlist which I have, however after restarting...

yes - this is sorted now. The recording was done on the first page and not the greeting page. Thanks for your help.

Hi there, I did a factory reset as it seemed to be looking for a CTL file, and would not register with CCM. it is not even going to the tftp stage as it keeps on rebooting and just goes through this all the time. Any ideas?

you could always use a FXS card in an NM2V. I have some dect phones plugged into my FXS and works nice along side the IP phones..

hi there. I have a 7970 which I did a factory reset as stated on CCO - however it will not come back - it just keeps on re-booting. any one got any suggestions apart from throwing it in the bin?

hi there, I have created a call handler with a menu type system. This appears to work fine, however when I get routed to this the "robot" says "sorry" and then my messages are played. Does anyone know how to turn this off?

csim will work on any voice router, however if there are no dial-peers in then yes it will not work. No reason why a pots peer cannot be setup also just purely for testing.

there is a CLI command in the router which is very helpful csim start 9123 the above will make a call dialing 9123 - match a dial-peer and go out the relevant port.

hi there, yeah, this would be pre-pending the number say 5000 - 5999 to say 7445000 - 7445999 make sense?

I dont have access to a router at the moment, but there is a command - I think its show sccp connection. but type in show sccp ? this will show you the options. This shows all of the conferencing streams and the codecs they are using!

EM only works when the PUB is up, as this does changes to the master DB. So no, when the PUB is unavailable thats it - the phone stays the way it is.

Hi there, just installing a CCM 4.1(3) on VMWare, have did the regedits to emulate a MCS. When installing the CCM s/w I get a error come back saying createProcess Error: 3: The system cannot find the path specified and the whole process aborts! anyone seen this before? I have tried this using...

this is only for internal, and for long term..

how can i query the DNS from the PC? if i type in say "ping cisco.com" it is unresolved. Many thanks