Recent content by Antwis79

Anyone have a Zip file for MatWorx Studio ?

Same old carrier story .. not their issue Repunched T1 cable Reset CSU Changed T1 cable to frame Thank you

Sv9300

So the PGd say it can handle both door box and external paging using o e extendion port dlc I was able to get external paging working (using first port on dlc blade to Pgd now I need a door box I have jumper set correctly and wires on unit in right place for both but cannot get door box to work...

User are complaining that Voicemails volume going in/out. Was able to duplicate by calling DID leaving VM and message volume went in and out completely. Calls route into 9500 over IP CCIS to 9300 then back to VM where 9500 is located my routes are 10, 12 , 14 Is this aPad issue if so what are...

On Tuesday desiless phones on 9100 if you have a key ring on second page say a cap key or virtual does it take priority when right gingnor donyou have to scroll when ringing to second page

I habe set up extensions in 46 command and created access code but TDM phomes not receiving all call page. Os there a command to turn on so that other will be proovded to each extension ?

I have 3 phones onsite that when dial out there is a delay from when their voice is heard from distant end. TDM phones. I have 100 other phones onsite that are not experiemcing this problem. Everyone dials out the same PRI , they are in same class of service. After about 5-10 seconds their...

Is there anyway to turn off the light on side car only when user programms one touch button to call another extension. They do not want itnto light up when other user is on their phone

I'm replying to my own thread In 2B you HAVE TO set a password and imput also on polycom.for it to register properly

problem getting IP6000 polycom to register All my ip phones work fine I have 5 stanard sip station licences My network 192.168.10.20 for SiP several Sub 255.255.255.0 Gateway 192.168.10.1 Port 5070 UDP only Dhcp is off on unit Extension 3898 Login 3898 Static address 1004 set std sip...

Thank you for response 08>140 = 0 1303 Xxx is set to 0 which is NOT def. 0= To provide (Fornstation with meassage lamp ) Still no light In found where to make it flash or solid once it works. In 08>294

1303 for subkines defaulted to provide

Have a customer need sublines or Virtuals for Departments to flash when there is a voicemail in the box to show on line key I found 08> 713 > 0 08> 140> 0 still missing something ,, not lighting with message in box

Hi can i download latest version software from NTAC and jump to patest from an old 2.02 . what is the best way to perform this upgrade via PCpro or Stick