Recent content by 642234

Dear All, I have TSE 3.2 with ISDN E 1.facing Caller ID issue.Name is not going at remote end also I can not see in coming caller ID. These are my rocap: ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP 1 7110000000001010 7 3100000001 0...

Dear All, Please help me . I have TSE 3.2 . facing problem with caller ID . My name is not going on remote end. waiting for response.

Thanks a lot

Hi, Please can some advise how to create SIP extension in Mitel TSE 6.0 version Thanks

Hi, Any body can help me please. some body press Euro conversion in charging module and now calls are being charging in Euro instead of dollar. I stop the call charging module . Please help me how I can bring it back so that call should charged in Dollar. Waiting for response. (Soft tex ring...

Hi, if its possible to downgrade the ELU 31/4 board to ELU 31/3, so that I can use the with 32 time slot in TSW SP 7. I tried to initiate CXCFI but massages come incorrect board type.

Thanks for every body. still I have same problem. sync cable is ok. there is no ring . I have only one card elu 31 in the pabx. when I dial disa after dialing disa I get tone of remote pabx I start my pin code but some time I can see on dect phone hang up. so line disconnect.pls advise

Dear Snor Yes I have problem with one dect extension. How I can check in mobility log. Please advise. waiting for response.

I have Astra TSW SP 07. My board version is ELU 31 ROF1375412/3 R1C CAA 158 0047 R2G EXE CAA 112 2940 R1F FB Facing problem with Dect connectivity . While making call...

Hi Doktor, Thanks a lot. I will intiate these commands . Is there any parameter changes in CAT for Analogue extension beacuse i will use analogue extension with phone soft for voice mail. Thanks.

Hi Dokter, Please can you send me serial integration command for NIU for voice mail with phone soft server. I have Aastar TSW sp 7 version Thanks

I have TSE 3.2 PELPI is not working with IP phone. locally it is working but it is not working external felloew me. But digital number and analog number are working with CDINI to local number as well as external number mean (other PABX).Please any body can advise what is problem. MDSH>...

pernum, Can you help in issue how to configured blustar 8000i with v 5.0

Is it poosible that we can use Blustar 8000i device with TSE SP 3.2 or with any other TSE with higher version. Thanks

Hi , Advise E-1 parameters between Ericsson R 13 MSC gateway 10 to MX ONE switch. Incoming call is ok but while dialing out some time getting TIME OUT If it is possible provide E-1 parameters. <ROCAP:rou=14; ROUTE CATEGORY DATA ROU SEL TRM SERV NODG DIST DISL TRAF...