Zebra ZPL II programming assistance please 1

[zarkon4]

I am trying to create a text file that has all the data I need to print. My problem is that I want my labels to be smaller than 2.5 inches and I do not want them cut between
labels. I am new to this and am having a problem fining what I want, which is 3/4 inch label length and not to cut until all the labels are printed. I am using continuous feed labels. Here is what I have so far. Can someone who is familiar with ZPLII please help.

^XA^MMC^MNN^MTT^PON^PMN^JMA^PR4,4^JUS^CI0^XZ
^XA
^LH0,0^LL500
^BY2,3,70^FT425,100^B3N,N,,N,N
^FD12345^FS
^FO400,110^A0N25,25
^FDCEMVAR1000X1000X20004FLHS^FS
^FO665,80^A0N25,25
^FD12345^FS
^XZ
^XA
^LH0,0^LL500
^BY2,3,70^FT425,100^B3N,N,,N,N
^FD67890^FS
^FO400,110^A0N25,25
^FDTLPG035625A^FS
^FO665,80^A0N25,25
^FD67890^FS
^XZ
^XA
^PQ1,0,1,N
^XZ

 

[MBumpy]

You have the Label Length command set to 500 (LL500) which is 2.5". Change it to 160 and it should give you the 0.75" you want.

Mark


^XA^MMC^MNN^MTT^PON^PMN^JMA^PR4,4^JUS^CI0^XZ
^XA
^LH0,0^LL160
^BY2,3,70^FT425,100^B3N,N,,N,N
^FD12345^FS
^FO400,110^A0N25,25
^FDCEMVAR1000X1000X20004FLHS^FS
^FO665,80^A0N25,25
^FD12345^FS
^XZ

^XA
^LH0,0^LL160
^BY2,3,70^FT425,100^B3N,N,,N,N
^FD67890^FS
^FO400,110^A0N25,25
^FDTLPG035625A^FS
^FO665,80^A0N25,25
^FD67890^FS
^XZ
^XA
^PQ1,0,1,N
^XZ

 

[zarkon4]

I have tried that, and when I do part of the bar code is chopped off.

 

[MBumpy]

I don't see that problem. I would suggest setting the defaults on the printer and try the again. Set the defaults by holding down the feed button until the LED blinks 4 times.

 

[zarkon4]

That worked, Thanks a bunch!