XMI001 and XMI002 on TMDI Cards Rls.5.0

[Abbott99]

I'm getting XMI001 and XMI002 Messages printing reguarding my TMDI cards that are used for regular T1s. The loop that i have programmed for PRI isn't printing these messages. They are printing every minuet. Any suggestions.

Thanks,
Nate

 

[PERRYPJ]

Change the card, those errors are telling you that the switch has lost card polling, and then the card response

OLD ROLMEN WORKING ON NORTELS

 

[Abbott99]

Have swapped card with another TMDI card, There are 3 Standard T1s programmed, it is happening on all 3 cards.

 

[curtismo]

Sounds like a call to ETAS/GNTS/whatever they call it today. The TMDI cards are/were nortorius for causing strange problems to occur. For example, if I FDL my card, I get a whole screen of errors until I disable and reenable it.

 

[curtismo]

Just curious, does it make any difference as to what card has the clock controller on it? (ie, does the PRI card have the CC?)

 

[PERRYPJ]

CARD THAT HAS CC NEEDS TO MATCH LD 73

OLD ROLMEN WORKING ON NORTELS

 

[Abbott99]

Ended up calling ETAS, the fix was to out my tmdi cards and program them all the T1s as PRI and the XMI Messages went away. I thought if they were programmed as PRI they required and DCH but i was wrong.

 

[curtismo]

So...if you have them programed as a PRI, how do you set the signaling (ex., EM4). And what if the encoding is D4, not ESF? Do you have all 24 channels available?

Sounds like a kludge to me.

 

[acewarlock]

Have these ever worked??




This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.