I recently replaced the drum pre-heater bulbs and everything seemed fine. The print quality is perfect.
However I've discovered that I now have another problem that presents with any multi-page document.... The first page prints out quickly (if it is already warmed up), but then each subsequent page says it is "warming up" again for about 45 seconds, along with the usual clunking sounds, then it prints out 2 copies of the page, then "warms up" again in between every page. I don't think it has to do with the pre-heater because those bulbs don't even come on again much once it has reached temperature and has printed the first page.
I will mention that I did put in 220V 300W bulbs, also there is small plastic piece and metal clip from the right hand maintenance drawer guide that has broken off. I couldn't see the purpose of this and have not replaced it yet. The maintenance tray locking lever still is in place though.
Anyone seen this multi-page printing problem before ?
Thank you.
However I've discovered that I now have another problem that presents with any multi-page document.... The first page prints out quickly (if it is already warmed up), but then each subsequent page says it is "warming up" again for about 45 seconds, along with the usual clunking sounds, then it prints out 2 copies of the page, then "warms up" again in between every page. I don't think it has to do with the pre-heater because those bulbs don't even come on again much once it has reached temperature and has printed the first page.
I will mention that I did put in 220V 300W bulbs, also there is small plastic piece and metal clip from the right hand maintenance drawer guide that has broken off. I couldn't see the purpose of this and have not replaced it yet. The maintenance tray locking lever still is in place though.
Anyone seen this multi-page printing problem before ?
Thank you.