ralstonral
MIS
does anyone have any idea how to configure ax330l1 expansion module in g700 without s8300 i have been trying but i cant get it to work
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
x330l1
- Thread starter ralstonral
- Start date
- Status
ralstonral,
x330 modules have no relation whatsoever to the s8300. these modules are for p330 switch family, including g700 media gateways, perform only data transmission tasks and do not have any relation to the telephony world. consult this document for installation and configuration instructions.
x330 modules have no relation whatsoever to the s8300. these modules are for p330 switch family, including g700 media gateways, perform only data transmission tasks and do not have any relation to the telephony world. consult this document for installation and configuration instructions.
- Thread starter
- #3
ralstonral
MIS
dwalin
i have already done according to what is in the manual
and it still does not work that is why i was thinking it may be a configuration issue
the g700 is linked to the main s8700 via single mode fibre which is four km away.
in order to get conectivity i have to use a ethernet tranciever and then connect it to ext1 port on the g700.
i want to get it working as the transciever introduces a point of failure
i have already done according to what is in the manual
and it still does not work that is why i was thinking it may be a configuration issue
the g700 is linked to the main s8700 via single mode fibre which is four km away.
in order to get conectivity i have to use a ethernet tranciever and then connect it to ext1 port on the g700.
i want to get it working as the transciever introduces a point of failure
- Status